20 Most Recent Bell & Howell Splash Wp7 Waterproof Camera Questions & Answers

See response to one of your other queries on this subject. BTW, repeating your queries does not increase your chances of a helpful response - usually quite the opposite, but I am feeling in a benevolent mood today.

The answer to this, and many other questions, will be contained in the manual. If you have no manual, you can download a manual for almost any equipment by Googling the make and model followed by the word Manual, then follow the appropriate link(s).

I had the same issue with My Splash WP 7. The key is there is a lever on the left side of the camera (the opposite side from where the buttons are) and it has to be in the up position for the Flash to work.

Hop into a camera store

It has to be a 16 or less other wise shows error

Pull black button while pushing door toward camera edge ^>

Hold the camera upside down. In the middle on the bottom side is a small grey tab. Push and hold that down and at the same time slide the compartment door to the left. Its tight and might require the use of a knife blade wedged down in the crack between the arrow and the screw the first few times. Yeah it could be easier but it is a watertight seal remember. It only slides about a quarter inch then it opens towards you.

you have to enter the entire tag info from the camera to get anything on line..model serial megapixels etc..

Slide the battery cover on the bottom of the camera to open the battery compartment. Use fresh 2xAAA bateries

Slide using a thumb finger along the line with slight pressure.

Hello, You can use VLC or QuickTime for video editing, I use Magix. I hope I've helped you :-)