Landice L7 Executive Trainer Treadmill Fitness Running Walking Exercise Review - Answered Questions & Fixed issues
Landice L7 treadmill won't turn on
1)LUBE the deck belt, maybe you have a deck belt worn, by lack maintenance.2) Lube the rollers bearings, in according with the maintenance schedule.3) Test the main motor for voltage input, if there are the motor need repair.4) Test the output voltage board, for input voltage motor, if there are NOT the board is faulty.5) After fixing RUN the software calibration for diagnose, and troubleshooting.
5/9/2012 11:03:07 AM •
Landice L7...
•
Answered
on May 09, 2012
•
4,305 views
My Landice L7 treadmill for home use races to speed when I turn it on. I cannot control the speed, it just increases automatically to top speed.
There could be a few different things causing your Landice L7 treadmill to race to top speed when turned on. Here are some potential causes and solutions:
- Motor Control Board: The motor control board may be malfunctioning and sending the treadmill into top speed automatically. If this is the case, you will need to replace the motor control board.
- Console Board: The console board may be sending incorrect signals to the motor control board, causing the treadmill to race to top speed. If this is the case, you will need to replace the console board.
- Speed Sensor: The speed sensor may be malfunctioning and sending incorrect signals to the motor control board. If this is the case, you will need to replace the speed sensor.
- Calibration: The treadmill may be out of calibration, causing it to race to top speed. To recalibrate the treadmill, consult your owner's manual for instructions.
It's recommended to consult with a qualified technician to diagnose and fix the issue to avoid causing further damage or injury.
Speed sensor L5
follow this steps and fix it. God bless you
SAFETY SHUTDOWN Loss of Speed Signal" or "L5" WITH belt movement
This is usually an indication of a speed control
malfunction. The upper board is not recognizing a signal pickup from the speed
sensor. This could be due to the speed sensor being misaligned, improper
connection, or bad speed sensor. Refer to the flowchart on page
"SAFETY SHUTDOWN Loss of Speed Signal" or "L5" WITH NO belt movement
The
speed sensor is not recognizing any motor movement. This displays the error message
to the upper board.
NOTE:
USE THIS FOR DIAGNOSING THE PWM/RELAY COMBO BOARD
My landice 8 tradmill says safe and will not move
1) rUN THE SOFTWARE CALIBRATION for diagnose and troubleshootin.2) Lube the deck belt 3) Lube the rollers bearing4) Measure the input voltage motor, if there are the motor need repair5) Measure the output voltage boad, for input voltage motor, if there are not the board is faulty. see the block diagramGod bless you.
Motor or belt sqeals -
this may require proper troubleshooting but it is either the belts on the motor needs changing or the track belt ihas come to the end of it's usage life... but check thorougly.
Not finding what you are looking for?