20 Most Recent
Bosch WAE24166GB - Page 4 Questions & Answers
Error e18
Could be a blockage in the hose...remove the filter cover and give a hefty blow down the end of the drain hose (give it a wipe first). If there is an obstruction along the length of the hose this should expel it. If this does not help then you may have a blockage between the drum and the pump, when the filter is out, poke your finger in the small opening in the pump housing at approx nine o'clock and see if you can feel anything. Hope this helps, good luck.
E47 error code Bosch washing machine
Hi Adrian.
this is all i can find,
Bosch Washing Machine E47 Error - Heat Sink on Motor PCB Fault
Description:
Heat sink on the motor control module is broken.
Action To Take:
- Replace motor control module.
- or go to this link it will give you all the codes.
- https://appliancefault.com.au/faults/washing-machine-faults/bosch-washing-machine-fault-codes/
I have a bosch nexxt 500 series washing machine . It is filling and draining st same time. What is causing this
It's likely that you have a siphon occuring. Check the position of the drain hose. The bottom of the end of the hose must be above the maximum water level of the washer. In some cases, you may just need to pull the drain hose up and secure it so that it isn't pushed too far down. For other cases, you might need to lengthen the stand pipe by adding a coupler and another length of pipe. (If you have the drain hose going into a laundry sink, you might need to raise the sink if there is no easy way to get the hose secured in a higher position.)
I hope this helps.
Cindy Wells
Not finding what you are looking for?