20 Most Recent
Briggs & Stratton Prosumer 2800 PSI (Gas - Cold Water) Pressure Washer - 20324 - Page 5 Questions & Answers
Snapper 28B707 wont start
Start by checking the coil for spark makeing sure the ground on the brake is releasing if you have spark the problem is fuel delivery check fuel filter if ok rebuild carburator or at least clean with carb cleaner.
6/25/2018 12:32:16 PM •
Briggs &...
•
Answered
on Jun 25, 2018
Wizard rototiller model 5hp. Briggs.
Not getting
is it a bowl style carb and you cleaned it is it a diaphram style and you replaced the diaphram ?the older 5hp briggs engines would run fine if you started it with carb cleaner some leaked head gaskets and could create enough vac to draw in the fuel
6/4/2018 5:45:59 PM •
Briggs &...
•
Answered
on Jun 04, 2018
How do you set the gap between the coil and the
Hello,
My name is Dane and I am going to help you solve your problem.
Too set the gap for the coil get a regular buisness card and use it as a feeler gauge. Loosen the bolts to the coil. Rotate the flywheel so the magnets are next to the coil. Slide the buisness card in between the coil and the flywheel magnets and make sure the coil is tight against the card.
Now tighten down your coil bolts and remove the busisness card. Turn the flywheel at least 1 complete turn and make sure it doesn't hit the coil. You're done!!!
Well, I hope I've helped. If you found this information useful, please leave me some THUMBS UP if you think I'm deserving! :-) Thank you! Dane
5/14/2018 4:12:05 AM •
Briggs &...
•
Answered
on May 14, 2018
Not finding what you are looking for?