20 Most Recent
U-Line Refrigerator Ice Maker - Page 5 Questions & Answers
Water leaks inside unit wher selenoid calls for
The fill tube that goes into the water cup of the icemaker make sure its in with a clip on the cup to hold it downwards. Sometimes the clip is off and the tube sprays out of the icemaker. Also check to see if flakes are in the ice. That would mean that the teflon is peeling off and forcing the water out of the icemaker.
5/14/2009 3:08:59 AM •
U-Line...
•
Answered
on May 14, 2009
U-Line co29ff, brand new unit. Makes clear, hollow, watery ice.
2 things you need to check. If you remove the icebucket look for armaflex the goes on the sensor tube from the icemaker to the back wall. If missing call U-line to get the correct one. The second thing you can do is check the icemaker control. Remove the grill, on the base in the right corner you will see a control with a screw. Turn the screw all the way to the right then back it so it will be straight up and down.That will set it cooler
5/14/2009 3:05:44 AM •
U-Line...
•
Answered
on May 14, 2009
How do i permanently discoonect
You should be able to shut off valve and just disconnect the line leading away from it. Sometimes these valves do not seal off completely however. If you have that happen, there is a 1/4 compression cap which can be screwed onto the valve. Look for one at a hardware store.
1/18/2009 3:36:57 PM •
U-Line...
•
Answered
on Jan 18, 2009
PEELING PAINT INSIDE A SMALL U-LINE ICEMAKER
What your going to have to do is shut the unit down and let it dry up you can't have any moisture inside it. use a enamel base paint any would do just be-careful, where your units paint is comming off is also the units evap coil you don't want to do much sanding. Hope this helps you
1/8/2009 3:35:59 AM •
U-Line...
•
Answered
on Jan 08, 2009
U-line model ulr-60b
hi,
periodical clean can smooth the operation of your ice maker.
at this link you can have the ice maker cleaning guidelines:
http://lib.store.yahoo.net/lib/usappliance/echelon-icemaker-manual.pdf
11/29/2008 6:42:42 AM •
U-Line...
•
Answered
on Nov 29, 2008
U-line ice maker BI-95
hi,
try to steady your thermostat setting to the lowest or not turned at all. more stock in your ref. can help your ice maker not to frozen. if you have less stock in your ref. put some gallons of water. or put your ref near the fire bin but not too close. or with a circulation of hot air
11/29/2008 6:22:44 AM •
U-Line...
•
Answered
on Nov 29, 2008
Combo75 icemaker
hi,
make sure you have enough stock in your ref. for the supplied water for ice maker not to be frozen. or if sometimes you have less supply inside your ref., then put some gallons of water and stock it in your ref. and in your thermostat steady to the lowest setting.
11/29/2008 6:03:14 AM •
U-Line...
•
Answered
on Nov 29, 2008
Squeaky noise
hi,
that squeaky noise is the sign of the compressor mechanical parts problem. a sign of compressor replacement.
11/29/2008 4:43:08 AM •
U-Line...
•
Answered
on Nov 29, 2008
U-Line icemaker is undependable
to make ice the thermo in the ice maker must be below 5 F...make sure there is a clear flow between the evaporator and the ice make also make sure you have a good seal between the freezer and the refrig areas..
1) put a cup of water in the refrig.
2)start with the coolest setting and move 1 setting every 24 hrs.
until it up until it freezing the water.
3) coolest you can get but not freezing the refrig...
hope is help
8/31/2008 12:03:15 PM •
U-Line...
•
Answered
on Aug 31, 2008
Fill doesn't shut off on Model WCM48
If it is just dribbling then chances are that there is debris in the fill vale preventing it from closing fully. Since it does not seem to flush out on its own then a new valve will likely solve your problem.
7/30/2008 4:01:21 PM •
U-Line...
•
Answered
on Jul 30, 2008
Not finding what you are looking for?