20 Most Recent U-Line Refrigerator Ice Maker - Page 3 Questions & Answers

Hi,

Check out these tips...they can help you figure out whats going wrong with yourrefrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold
heatman101
f

Hi,
Here is a tip that I wrote about the reasons why ice makers do not work.

Ice Maker Problems and Ice Maker Troubleshooting

heatman101


kjkjl

Hi,
Here is a tip that I wrote about the reasons why ice makers do not work.

Ice Maker Problems and Ice Maker Troubleshooting

heatman101


767676

I don't really think there is much truth to that. Think out outside air conditioning units. They use the same freon and compressors and work quite well in warm temps.
Freon does expand and freon's basic boils at a temperature that is optimal for the operating conditions of a typical air conditioner. The warmer it gets outside, the cooler the freon get inside.

Refrigerator not cooling.This is the indication of drain line blocked or the defrost system not working.The other possibilities for this problem are.:-- The compressor not working,The compressor fan not running, The coils are dirty,The ventilations blocked. Also mention the exact model number of the refrigerator so that exact faulty part and its location can be mentioned in your refrigerator. You can get required parts from www.repairclinic.com
Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

replace the water valve . it must be leaking trough to cause this problem .. mm

Does the ice maker work? If it does it may just need an o ring or washer where the waterline connects to the ice maker. You can also remove the supply line from the valve and cap it.You will not have automatic ice but trays are cheap at the dollar store.hkjohn

Look at the thermostat and at the programmer/control board - they are the ones that control the power to the compressor. Check first that the power is transmitted to the compressor, then if it's received. If it's received you can do one more check of the compressor - connect it directly to the mains, if it's good it should start.

Hi, If you can move the wires at the board and it works for awhile, look the wires over good, but you will more then likely need to replace this board. I wouldn't recommending soldering it as you are taking a chance on soldering other parts of the circuit together causing more problems. I have soldered boards, blower boards on a/c & heating equipment, as I have the know how, but you should look into the price of a new board. You will need to go to a appliance parts store to get it or order one. I wish you the best of luck on this and was hoping to save you money. If you want to try and solder, you really don't have anything to loose, as if it does not work, you will need a new board anyway, so give it a try. If I have been of help to you, please rate me and I ask that you be kind when doing so. This would be very kind of you for doing this. Please keep me posted on this.
Sincerely,
Shastalaker7
A/C, Heating, & Refrigeration Contractor

Shut it off, let everything thaw out overnight, then start it up again.

Hi there,
I would suggest calling a professional repairman or better yet, contact the U-Line service center.

Hi,
The arm should be down to make ice....

Also check out this tip that I wrote for more troubleshooting...

http://www.fixya.com/support/r3876071-ice_maker_problems_ice_maker

heatman101

Hello. Here is the link to all of the information regarding this product. http://www.u-line.com/products/product.cfm?p=6

Joe

bad water valve, thermostat, freezer not cold enough, make sure the ice maker metal rod is at down position or on back of the ice maker plastic water line is frozen. also depends what year combo you have, there operation is a little different.

It is on the back of the machine, if you have clear ice maker, it may be on the back of the front plate.