20 Most Recent U-Line Refrigerator Ice Maker - Page 2 Questions & Answers

go online to www.searsparts.com and put in your model they might have it there

It could be the solenoid where your water line comes in from the wall and sends it up to the freezer. Follow your water line to the bottom of the frige it could either be in the back or the front. Might try looking under the fridge to see if you can see it that way.

Check the main drive gear for a missing tooth: If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

your water line inside your fridge is probably froze. turn it off for about 30 minutes, see if it thaws.

The ice maker not working: ---

Its the problem of water inlet valve. It's a dual valve. This valve has two tubes in it. One for water dispenser and one for ice maker chamber. The one side of valve is working, but other side of the valve is not working. The valve is got stuck in one position

Click this link below to troubleshoot the problem: ----

http://technoanswers.blogspot.com/2011/06/ice-maker-stopped-working.html

---------------

This will help. Thanks. Helpmech.

NOTE: This
is a multi-solution answer since I don't have all the tech from your question to pinpoint your problem
But the solution is in here generically, if you read and study the solutions very,very carefully.
Check Temp inside freezer. It has to be down to about 10 or 15 degrees
This can cause slow ice making if its too high even tho its freezing everything else at 25 degrees
The ref. temp should be about 33-35
The Freezer temp should be 0 to 10 Any thing below these temps is overkill and a waste of elect
The higher the number you turn it up to is the coldest
The icemaker is 110v
See if water is in icemaker.
Pour water in Ice Maker and wait to see if it ejects.
If it ejects thenyou need to replace water valve in rear bottom of fridge(Its the part that
attaches to water line out of wall)
If it doesn't eject then it is a faulty Ice Maker.
If its leaking or no water at icemaker or door either one, then the valve at the rear bottom of ref needs replacing
I would check the fan in the freezer. Listen to see if it is running
It moves air to the ref from the freezer
Then check to see if freezer control is turned WARMER, which makes the Ref. colder
Also if it is getting drinking water to the door but not to the icemaker (or vice versa) Then you need to replace
the water valve at the bottom rear of the fridge. It is a double valve and one side is not working
Also this might be a common Defrost problem, Ice
is not being melted by the defrost system.The fan can't blow through the coils into the fridge.
Take out back panel of freezer to check for ice buildup. The coils should be clean.
There are three components to a defrost system- a heater,heater thermostat, and a timer unless you have a defrost electronic card.
Its best handled by a Technician but you could possibly do it by taking your model number to the nearest appliance parts store and asking for the parts. They are mostly located in freezer ,behind back panel on freezer coils.except the card which is usually located in ref The parts store will have info
Also check fan undernearh Ref in the rear
Clean condenser coils underneath
WATER SPLASHING IN FREEZER AT ICEMAKER
THE FILL TUBE IN BACK OF REFRIGERATOR CAN SLIP
AGAINST THE FILL RESERVOIR CAUSING A PARTIAL BLOCKAGE
OR BECOME CLOGGED WITH ICE.
REMOVE THE ICEMAKER AND INSPECT THE FILL TUBE.
RUN WATER IN TUBE TO ELININATE BLOCKAGE AND CHECK
TEMP IN FREEZER. IF TEMP IS BELOW 0 DEGREES, THATS
OVERKILL AND USUALLY A WASTE OF ELECTRICITY TO KEEP IT THAT COLD, NOT TO MENTION THE FILL TUBE FREEZING UP
If you still have trouble GO HERE:

hhttp://www.applianceaid.com/procedures.htm

I'm including my article on Refrigerator Repair for your help and convenience.;
Please click or copy and paste into browser for Article

http://www.fixya.com/support/r5816737-fix_refrigerator_psychologically

Thanks for using fixya
Leo Ponder
imufo2
PLEASE GIVE A TESTIMONIAL AND VOTE FOUR THUMBS UP IF THIS WAS HELPFUL

Hello

There is a water valve inside the bottom behind the panel,you can take it to a local appliance parts dealer and they can get you a replacement ,, most likely the valve is nolonger working

Hi pachingoman,

If you're experiencing water leaks into the ice tray, it is often caused by the water inlet valve. This is sometimes called a weeping solenoid. The easiest way to correct this is to check if the valve is seal properly or dirt has come between the seal of the valve. If the seal itself is bad, please replace the water inlet solenoid valve. Here are additional troubleshooting that you may apply on this issue.

1. Check to see how big your ice cubes are.

2. If your ice cubes are very large, then then is sounds like your valve isn't sealing off and the water valve will need to be replaced.

3. If the cubes are smaller, then it sounds like the icemaker is leaking water out into the bucket causing the cubes to be small and the bucket ends up a big block.

4. If it doesn't happen all the time, sometimes frost will build up under the icemaker and all you need to do is just thaw the unit out for 24 hours and the problem will fix itself.

It is common for the ice maker to leak overtime. However, if the ice cubes are smaller you definitely need a new ice maker I'm afraid.

Hope it helps.

Thank you for using FixYa.

Your feed line may have a leak in the line itself or in one of the connectors. This it the line that sends water to the automatic ice-maker. Check the line coming from the wall to the ice-maker connector and slide your hand down the line. You will find water somewhere along this line and you have found your leak. This should be very easy to fix.

Hello
The control you have #80-26005-02 has the same number position as the 2717. The numbers are listed on the new control.
The red wire goes on #1, the yellow #2, and the black or blue black goes on #3. The numbers may be difficult to view, but they are printed on the new control.

my hzb12 DONT WANT TOMAKE ICE IT WILL TAKE WATER BUT NO ICE CUBES COME OUT

if it doesnot get cold it wont make ice. u need to check to see if comp. is really running. might have a bad relay on comp. ok