20 Most Recent
RCA D52W19 52" Rear Projection Television - Page 9 Questions & Answers
Will not turn on
If you replaced the FL231 without replaceing the DL231 it will usually work for a little while then fail. However if the sound youre hearing now is a short sharp chirp which coincides with the power indicator its often caused by a failed flyback and HOT Transistor, if the sound sounds like a soft psssst three times then DL030 and DL032 all items are on the Deflection/power board.
My tv is showin 3d
There is a repair kit called the ITC222 & ITC222A convergence option missing repair kit from
www.tvrepairworld.com which should solve that. The kit comes with the parts and the CD with instructions.
When turning the power on
Hi
Thanks for using FixYa. Please post back with the no# of blinks the green light
flashes in 10 seconds so that I can further assist you.
Thanks
Rylee
Pictures looks 3 d
The tv have a problems known as a convergence problems,it dead.The tv convergence board require it 2 STK convergence ICS and some or all it resistors to be replaced to solved the convergence problems.The shop will cost u $300-350 for parts and labors.
Removing front speaker panel
these just pop of but be carefull the plastic is thin just carefully pull forward and it will let go. 1 side at a time.
I have a RCA D52W17 rear projection T.V. When I
Hi
Thanks
for using FixYa. 3 blinks in your RCA D52W17 rear
projection are caused due
to 3 capacitors (CP114, 120 and 150) which are located on the deflection board.
If any of these capacitors goes bad you’ll have to replace them with the exact
same ones. Please
do rate the solution if the issue is resolved or post a comment for further
assistance.
Thanks
Rylee
Power supply, where can I get a power supply board.
if you know the compoment parts that need replacing yes if not order the whole replacment power bord from rca call there service parts number give them the tv model and they will be able to send you the entire replacment part
Not finding what you are looking for?