2002 CHEVROLET EXPRESS 3500 - Answered Questions & Fixed issues

check what is missing spark or fuel

If your cold start mechanism(s) always stays on, it will be difficult to start a hot engine if at all. Could be a bad sensor or defective ECU.

What is the question? Widely available and standard installation.

Could be a bad thermostat.

Normally when you apply a higher amperage load to anypart of your 12volt electric system. The Load or amperage needs a very good ground. I would suspect you either have a loose/weak/dirty ground connection somewhere either in your harness or all the way to even a dirty battery connection. Try to use a jumper ground wire directly to a clean metal surface neer the rear lights that are going off when you hit the brakes and the window/middle brake light comes on. Anytime you have electrical issues, always clean your battery and make sure you have full voltatge connections on both the Postive side and the negative ground side. Check the voltage on the light socket as well, if you suspect a low voltage situation. Also check all light bulbs for clean light bulbs grounding and terminals. Good Luck

The rear side door actuator control modules monitor the power sliding door positions at all times. Whenever the battery positive voltage supply to a rear side door actuator control module has been removed or the on-board diagnostics have been activated the power sliding door system(s) must be re-initialized. Re-initialize the right or left power sliding door systems using the following steps:

1. Turn the ON/OFF switch for the power sliding door system to be re-initialized to the OFF position.
2. Manually open the power sliding door completely.
3. Manually close and latch the power sliding door.
4. Turn the power sliding door ON/OFF switch to the ON position.
5. Open the power sliding door completely using the B-pillar or overhead console OPEN/CLOSE switch.
6. Close the power sliding door completely using the B-pillar or overhead console OPEN/CLOSE switch.

What is the question?

165 ft lbs

have truck scanned for a trouble code active or pending this will cause no start conditions

It is still immobilized through the alarm system then.

http://repairguide.autozone.com/znetrgs/repair_guide_content/en_us/images/0900c152/80/25/f9/97/large/0900c1528025f997.gif We Are Here To Help !!!

Yes. The inner door panel needs to be removed since the switch is on the inside of it.

The code is: P2000 NOx Trap Efficiency Below Threshold Bank1 and I do not know what that is unless it has something to do with the oxygen supply to the engine. Sorry I am not much help.

sounds like the alternator is not putting out. If you start the car and remove the battery cable and the engine shuts off then the alternator is bad and you need to change it.

take the screws out of the arm and take it down.

check everything else, I don't believe it has one

chevy aveo wiring diagram Google Search

1996 Camaro Z28 Wiring Google Search

it that on the door the heater the radio the steering column or on your Sony Walkman??

You tube that question, watch the video and disable it forever or get a new key