20 Most Recent
Apex Digital AT2702 27" TV - Page 5 Questions & Answers
Apex manual
i am locked out blue screen red key what do i do
Black Screen with sound
make sure the TV time is correct. Reset the time. if that does not work, but the TV operates ok, it's in the circuit board, or could be a fuse problem.
AT 2708 Apex TV
Try using the A/V jacks in the back and putting the channel to INPUT 1, 2, 3. Th cable you're using may not be correct, like the slide-on cable that would come with a vcr.
White lines in tv whats the problem??????????????
Check the cable that you are using. If it's a "single" shielded cable, it maybe letting in "air" frequencies, like you have an antenea hooked to your TV. Especially if you live in a city that has several Tv stations near you. The cable could be to old and has breaks in it, or not grounded properly.
Hello
You can try to use the "common code" - 0- all zero's. Unless you have an actual code that you have set up in the TV. Another way would be to unplug the TV for a day, or try to remove the fuse in the back.
Loses power
I have seen this problem on a lot of TV's. It's caused by the picture tube. One or more of the wires have a break in it.
Apex AT2702
i think there is an option called music mode ....
so may be it is running in music mode check it....
if not then may be the tube is gone or may be some capacitor is burnt out or may be some wire connecting to display circuit board is in mis contact .. ....
just take your tv to technician ....
the technician will recharge the tube or he will give other solution for it ....
if you are good at opening then just open it and have a check whether any capacitor is burnt out...
if you are not good at opening or if you are afraid or if you dont have any idea then just take the tv to technician ...
any way it doesnt cost too much ...
Tv digital
You will need to purchase a converter if you do not have sat or cable and desire to bring in off-air channels...accordianman
Apex PF 2720
If you have the remote control go to the main menu and select features lock on/off option and switched off the option. Even you did not solve the problem this can be solved by the master reset method by changing EEprom ic.
SAttelite help!
Unplug the satellite receiver for a minute or two especially if your connections are right.
Picture, but No Sound
I doubt if it has fuses as most sets have what are called fusable resistors and these as fuse hardly ever go bad for no reason. these devices are there to protect the rest of the set incase of a short and to stop it from blowing up or burning. Fuses or fuseable resistor go our because of a short circuit. In your case the sound output IC or the capacitor assciated With it. Good luck
I need to know how to change modes without controller when I'm using a dvd
Without a remote controller, you may have limited options to change modes on your Apex digital TV. However, you may be able to change the mode by using the buttons on the TV itself.
Here are some general steps you can try:
- Turn on your TV and make sure your DVD player is connected to it.
- Look for the "Menu" button on the TV and press it.
- Navigate through the menu options using the arrow buttons on the TV until you find "Input" or "Source."
- Press the "Enter" button to select the input/source option.
- Use the arrow buttons to select the input/source that corresponds to your DVD player.
- Press the "Enter" button to confirm the selection.
- Press the "Menu" button to exit the menu.
Note that the specific steps may vary depending on the model of your Apex TV. You may also consult the user manual for your TV for more information on changing modes without a remote controller.
Not finding what you are looking for?