Mercury Floor Machine Mercury: Ultra DC Burnisher 21in - 1.5hp - 1500rpm - Floor Machine - Answered Questions & Fixed issues

The switch has gone bad. Very common on these. The contacts in the switch wear out and then get welded together. The motor draws a lot of power when first started and this is ******* the switch.

Timber Floor Sanding and Polishing Melbourne Use this guy, i have used them before & they are very affordable & professionals for sure

www.electroluxappliances.com/Owner-Support

I apologize, but I need more information about the specific model of the Eclipse propane floor buffer to locate the manual and provide troubleshooting steps. Can you please provide the model number or any additional details about the buffer?

The rectifier is in the top end of the motor. Take the cover off and then the top end plate of the motor. With the bolts removed, you will have to tap and rock the plate to evenly remove it. Carefully look at the marks on the old and new part to be shur you do not make a mistake in the wiring. A drawing and photo might be nice too.

Any janitorial supply in your town, or ebay. Your Home Depot or Lowe's may have them as well as Amazon.

What exactly is the question here? Is this a corded electric Scrubber or a battery one?

motor bearing worn or shaft bent.

Wax remover. Rewax spot after removing wax.

www.sears.com/search=kenmore%20floor..

www.cleanfreak.com/Qstore/p001525.htm

the brush is either dirty or you burned the wax.

Plug it in,pull trigger

sometimes questions get put in the wrong category, the question has been sent to the correct category.

Try Amazon for floor polishers and buffers. Here is a link to some of the better rated products they have available: http://www.amazon.com/s/ref=sr_nr_p_72_0?rh=n%3A1055398%2Cn%3A%211063498%2Cn%3A510106%2Cn%3A510118%2Cp_n_feature_keywords_browse-bin%3A4463189011%2Cp_72%3A1248915011&bbn=510118&ie=UTF8&qid=1385971884&rnid=1248913011

My swing scrub was acting like that from a loose wire at the capacitor... it is after all a capacitor start induction run motor.

simply turn them counter-clockwise

over 1000