20 Most Recent Konica Minolta PagePro 1350W Laser Printer - Page 2 Questions & Answers

Clean the contact of the small electrical contact on the cartridge and where those contacts make contact on the machine normally front of the machine with alcohol. some times hands get oil on the contact so there no good electrical contact, though occasionally you do get a bad cartridge. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Print drivers current? Will it print its own internal prints demo page counter page? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Recommend have some one come out and look at it. Or take it to a Konicaminolta dealer ship Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Which pressure spring part number would be a start, location in the machine? Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

You can open the back portion to remove the stuck paper if it is in that area otherwise remove the bottom cover and clear it

Could be the fuser, or the drum is not getting the charge on that side.

OK, download the new driver from the website and install. Next, go to control panel and go to printer. Right click on printer and select "properties" Click the tab that says "ports".... uncheck where it says "print to file" and then check the box that says "USB"... this is what i did and it worked. Good luck!

http://www.konicaminolta.eu/en/business-solutions/support/download-center.html This is the main page for KM driver download. please select printer than model and finally the operating system you are working for and than you can download the driver you need.

Check paper sizes

error flashing and fails to get print outs

it is not fax , This is printer

need to replace toner cartridge

Go to printer faxes check and it might change the default setting and it might default Microsoft Office Document Image Writer. When you print make sure that you are printing to a right printer you can select the printer of your choice by clicking the down arrow. If you select the right printer and it did not print I suggest that uninstall the print driver to the control panel, add or remove and install a new printer driver. make sure set as a default.

pleas install status monitor, it will tell you what is wrong

Use the Vista 64 bit driver. konica Minolta drivers are/will be part of the system 7 load.

Jacques,

Print speeds will vary based on a lot of factors. First thing to note is that your printer should have a first print time of about 20 seconds. This means the first page should take about 20 seconds before it starts printing and than will print at rated engine speed.

Secondly, depending on the type of paper and thickness your speed may slow down. Most printers will slow down for a thicker paper. In general the thicker the paper the more time it needs for the toner to fuse or melt to the paper.

The size of the paper will also greatly affect the speed too. Manufacturers spec their machines to letter size in the portrait orientation (the leading edge is the 11 inch or long side). In general for legal you will have a 15 to 20% reduction in speed and for 11 x 17 you can have as much as a 40% or more reduction in speed.

Print resolution may affect the speed. Usually most printers will print faster in a draft mode. This may also reduce the amount of toner used.

How do you connect to your printer? Different cables all have different speeds. For that matter is there an upgrade to the RAM? This could also change the speed of the print job. However these should not affect the final speed too much.

So to get the "rated" speed of your printer you will need to use standard letter paper with the long edge leading. Remember don't use thick paper and use a draft mode or lower resolution if possible to get the best speed.

I hope this helps.

Henry