20 Most Recent Husqvarna Riding Lawn Mower 46 Cut Kohler Yth21k46 Questions & Answers

There a small gasket goes on screw

Husqvarna Riding... | Answered on Apr 29, 2018

Where is the 20 amp fuse located in YTH20K46

TO REPLACE FUSE Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

Here is the instruction manual: http://www.husqvarna.com/ddoc/HUSO/HUSO2006_USen/HUSO2006_USen_O0602057_.pdf

Husqvarna Riding... | Answered on Apr 29, 2018

1 Answer

Yth2246 Husqvarna tractor 2 months old and blowing

2 months old --still under warranty --take your p[roblems to the service dealer for a warranty fix

Husqvarna Riding... | Answered on Mar 03, 2018

1 Answer

I have a Murray 17.5 HP Twin 46" automatic drive riding mower that only moves very slowly. What are possible causes?

If the transmission is hydrostatic and has some hours on it, the transaxle may be going bad. If this has been getting worse as you use it. If the problem happened suddenly, could be a belt loose or stretched.

Husqvarna Riding... | Answered on Dec 12, 2017

1 Answer

Engine runs good but dies when blade or forward/reverse engaged

You have a safety switch bad. Could be the seat switch or clutch switch.

Husqvarna Riding... | Answered on Dec 04, 2017

1 Answer

Mover has no power getting to it all of a sudden.

If the battery is good check the battery connections are clean and tight.

Husqvarna Riding... | Answered on Jul 13, 2016

1 Answer

Mower jerks when going up an incline.

Belt spilling

Husqvarna Riding... | Answered on Apr 26, 2016

1 Answer

MY BELT SEEMS LOOSE AND THE BELT ROUTED RIGHT BUT COMES LOOSE WHEN I ENGAGED IT

Hi Randall, The link below is to a web page with a few different free husqvarna riding lawn mower manuals. I would've give you the correct download but you didn't mentioned the year, Anyway this should help you.... CHEERS..
https://www.google.com.au/search?q=Husqvarna+Riding+Lawn+Mower+46+Cut+Kohler+Yth21k46&oq=Husqvarna+Riding+Lawn+Mower+46+Cut+Kohler+Yth21k46&aqs=chrome..69i57&sourceid=chrome&ie=UTF-8#q=user+manual+for+Husqvarna+Riding+Lawn+Mower+46+Cut+Kohler+Yth21k46

Husqvarna Riding... | Answered on Mar 30, 2016

1 Answer

Cranks, runs @ 30 seconds and quits. wont restart until cold again

sounds like a fuel problem .

Husqvarna Riding... | Answered on Sep 07, 2015

1 Answer

The left side blade on my YTH21K46 is vibrating and is chopping up the lawn, it seems to be very loose when I inspected it compared to the left side blade. Is this a bad bearing or bushing problem?

Have you tighten the blade up? If the blade is tight, you have a bushing/bearing problem.

Husqvarna Riding... | Answered on Jul 06, 2015

1 Answer

Blades will not engage

when you actuate the "engage blade" lever, two things may occur,
First, a mechanical action, a spring moves to put tension onto the belt.
Second; at the end of its run, actuate a switch (PTF switch) to engage the clutch that moves the pulleys that consequentially move the blades.
if the tensioner is not moving , check if spring has come lose, undone or broken, (more likely in your case) or check the PTF switch.
any other assistance, contact me, good luck.

If you need further help, reach me via phone at https://www.6ya.com/expert/gerardo_79638d1eac6a0a1f

Husqvarna Riding... | Answered on Jan 24, 2015

1 Answer

Model rz4623 zero turn deck belt is jumping a lot

see if belt has burn spots in it that will cause it to jump excessively

Husqvarna Riding... | Answered on Sep 16, 2014

1 Answer

Engine will not start but solenoid grinds

SOLENOID DOES NOT GRIND FOR IS NO A MOBIL DEVICE, IT MIGHT BE THE STARTER WHAT IS NOT WORKING, SPECIFICALLY THE ACTUATOR THAT MIGHT BE STUCK, DISMOUNT STARTER AND CHECK SPRING AND GREASE THE SHAFT NO TO MUCH.

If you need further help, reach me via phone at https://www.6ya.com/expert/gerardo_79638d1eac6a0a1f

Husqvarna Riding... | Answered on Sep 05, 2014

1 Answer

Lawn mower is smoking white

to much gas check to see if chock is off or replace bad fuel siliniod rebuild carberator

Husqvarna Riding... | Answered on Aug 29, 2014

1 Answer

Wherem is the transmission

the back were the rear wheels are you need to check the fluid or just go ahead and chang hdrostatic fluid and filter best thing to do

Husqvarna Riding... | Answered on Aug 29, 2014

1 Answer

My husqvarna kohler yth21k46 is 2 days old and i turned it on ran for 20 mins and smoke came out from engine gas leaking from bottom of the air cleaner thought it was going to explode . what should

After reading your question it sounded like the smoke was due to fuel leaking on the muffler and or excess fuel entering the combustion chamber. I would due the following diagnostic. In a quite area turn on the ignition switch. You should hear the metallic click of the fuel cutoff solinoid on the carburetor.

Husqvarna Riding... | Answered on Aug 16, 2014

2 Answers

I replaed the blade drive mandrel and reattacheed the blade and the blade does not freelyturn t is so bound up tht I cannot turnit manually

okay check see if brakes is on the mower, not the tractor but the blades of the mower deck if not then take belt off of the new mandrel side and try turning blade by hand. should turn freely if not mandrel is bad but unlikely. sounds like you changed wrong side mandrel I presume you have 2 blades and mandrels. or when you installed it back on. the belt may be bound up between a guide and pulley just kind of look things over before a tear apart. and then do your tear apart one step at a time then check blade to see if it turns does not seem serious you may have put belt on wrong, I have done it my self. hope this helps major note do not do this with engine running cut you hand off in a flash.

Husqvarna Riding... | Answered on Aug 15, 2014

2 Answers

Spark plug keeps getting soot on it

an indication of running rich . check that the air filter is clean and not blocked-- check that the choke control is off after starting--check float level and operation of needle and seat.

Husqvarna Riding... | Answered on Jul 13, 2014

0 Answers