20 Most Recent
Kenmore Elite 45986 Front Load Washer - Page 2 Questions & Answers
Kenmore elite 5t steam f35 and sud problem
The
F35 error code indicates a problem with the analog pressure sensor, air
hose or air trap. If the hose and trap are good you will need to
replace the pressure sensorThe "Sud" error code indicates too
much or the wrong kind of laundry soap was used. Be sure to use only HE
(high efficiency) detergent on this model of washer.Please see the links provided below for access instructions & other troubleshooting tips covering the error codes displayed:- Link 1- Link 2Hope this helps (remember to rate this free answer and leave some testimonial).
Clothes have a musty smell if left in the washer
Make shure to do a cleaning cycle. As well, wipe out the inside, the rubber gasket and the door when done washing for the day. We also have found that
leaving the door "Open" for several hours, when finnished, eliminates any future
smells.
Our kenmore elite quiet pack
Always start with the simplest thing, verify that the outlet is good before troubleshooting the machine. I cannot tell you how often the home electrical is the problem not the machine.
Kenmore 'elite' HE3 front loading washer
I have the same problem. Nothing works fcfor the mildew. i have bleached it, used simple green and used baking soda. That washer is the biggest piece ever!! Good Luck!
I washed some very dirty baseball pants on Whitest
Try this: Soak the stained clothes in a solution of 1 quart of warm water, 1 teaspoon of liquid dish detergent and 1 tablespoon of white vinegar for 15 minutes. Then, rinse with water.
If this doesn't get everything out, then wash in warm water (or what the fabrics allow) using a color safe bleach and detergent.
The problem is that there was more dirt than what your detergent could handle. If you have a really dirty clothes item in the future, get as much of the dirt off using a vacuum or by soaking alone as you can. Then wash the item in warm water with detergent and color safe bleach.
GE Washer WSSH300GWW front loader washer CONTROL LOCK!!
Solution: Hold down the power and delay start button at the same time. In about 3-4 seconds a beep will occur and the red key lock will turn off. I think it is a problem in the machines firmware. I just guessed at what combination of buttons the engineers used to do a firmware reset. In any case it worked for me.
Not finding what you are looking for?