20 Most Recent
GE WBSR3140DW Top Load Washer - Page 8 Questions & Answers
Not spinning
Hi,
Problems with a washing machine not spinning or not draining are often inter related..
If you are having a problem with your top load washer then check out this tip...
Washing Machine does not Pump or Spin
If you are having problems with your front load washing machine then checkout this tip...
Front Load Washing machine not draining and or not spinning
heatman101
CROSLEY WASHER CAW9244XQ2 NO FILL
Hello Greg Aguilar - Are the house valves turn on fully? Washer not filling with water can be caused by many reasons. Most common cause is a faulty switch that doesn't allow the value inside turn or a kinked fill hose. Other possibilities can be water valve faults, faulty control board, pressure switch or wiring failure. Since you have just recently purchased the washer, I strongly suggestion contacting the manufacturer for a listing of certified techs that can move forward accurately.
GE Washer won't drain or spin
this is something that you can fix even if your not a technical person . first you have to open the washing machine front panel or back panel , second , follow the DRAIN HOSE to where its connected to a little motor, disconnect the DRAIN HOSE , take the LITTLE MOTOR out and clean it out , it could be clogged.
it happen once and find out the person put the BATH RUG SET
to wash , the rug was so old that pieces of a rubber underneath the rugs clogged the drain , so there was no rinse and no spin.
try it , I hope it helps.
Whre5550k2ww
The motor/inverter on this washer stores fault codes. The LED you see blinking will blink once every second non-stop when in stand-by mode and twice every second non-stop when it should be running. If there is a fault code the LED will blink a certain number of times then stop for a few seconds. Some of the fault codes not allow the motor to operate. Post back the blink code.Regards,Richard Rothhttp://appliancecafe.com
Repair manual for a bosch front load washing machine
if it has a bottom panel remove that and the tech sheet should be located one either the right side or the left side of the frame of the washer. If it does not have a bottom panel then remove the two or three screws from the rear of the washer that connect the top cover. This cover then slides backwards off the machine and your tech sheet will under there. If you have proper power going into the machine but have no lights on your display it could be quite a number of different things unfortunately.
Not finding what you are looking for?