20 Most Recent
All-Pro SPC-30 Heater - Page 2 Questions & Answers
I have a All-Pro torpedo heater ran by propane tanks. I can't get it to come on. U can hear the igniter igniting but can't get it to come on. Any suggestions.
If gas is being supplied to the heater without problems but it isn't getting through to the burner it could be a safety device problem.
There is generally a gas cut-out valve that is operated by a thermocouple. This is often in assembly with the main gas control and usually the control has to be pushed in or turned beyond maximum to over-ride the safety cut-out for starting purposes. Once the gas jet is burning the thermocouple rapidly warms up and the main gas supply is switched on the control knob can be released.
Disconnecting the output from the valve would indicate whether the valve is faulty or the jet is blocked. If no gas is passing through the valve there could be a fine gauze filter in the inlet that is blocked.
I hope this helps.
Have 85000 but all-pro propane heater. starts fine good flame, release the gas valve button, heater shuts down no gas
If you have a thermocouple and standing pilot as described the gas cannot flow full to the burners with the gas valve button depressed because the position of the gas valve to allow the button to be depressed is not in the 'on' position....its in the 'pilot' position.
Are you sure you cleaned the 'thermocouple' and not just a 'spark ignition electrode' ?? One with spark ignition will not have a gas valve that has a pilot position.... Kinda confusing and conflicting data to sort through ..... Hmmmm....
If you have the spark ignition style, the problem COULD be in the 'flame rectification' circuit. IF it has the ignition electrode, the other side of the furnace will contain the 'flame sensor' that senses the flame and completes the ground circuit of the electronic module through the flame. Its not doing it, so either it is oxidized up inhibiting its ability to conduct electricity through the flame or there is residual oxidation within some of the terminal connections of the ground circuit.
IF what you have is the 'standing pilot', the first suggestion is to replace the thermocouple. A more remote possibility is the gas valve has a defective safety coil that drops out when you release the pilot button.
Operating manual for doortronic lift king lk800
Hi Murray,
try this link I've used it many times before to find user manuals for products I've lost or for example, I just moved in to a new home but the sellers didn't have any of the op manuals for water softener/ alarm system, garage door opener, etc....
www.manualsonline.com
hope it helps!
Tune up cost
TURN OFF ! DO NOT USE!! SOUNDS LIKE CARBINE MONOXIDE. CAN KILL YA. HAVE EXPERT LOOK AT IT
Not finding what you are looking for?