20 Most Recent Whirlpool Accubake SF362LXTS Kitchen Range Questions & Answers

You may need to replace the part called the igniter module. It is what creates the spark that fires the gas.

If it's a gas range, I'd guess you have a pressure problem at the source. There should be some sort of pressure regulator at the gas tank. It might need adjusting or replacing. In other words, your oven might not be getting enough gas pressure to create a large enough flame. It should take only five or ten minutes to reach 400 degrees.

The yellow flames is a sign of poor combustion which can release carbon monoxide. It sounds very much like the range was supplied with jets intended for natural gas which operates at lower delivery pressures.
You need to ensure that the range is usable in its current condition can be used with propane. Labels on the range (generally in back) should carry warnings about the proper gas and pressures.

Tappan gas range, TGF334BCWB. I can NOT stop the broiler burner from lighting. I have unplugged the 110 power and I light top burner with a striker. However when stove is plugged in to the power the broiler burner lights and continues to burn. The oven knob is turned OFF. The only way to stop the broiler is to unplug the power.

Not familiar with this model but most likely cause is faulty switch .

It's time for a new thermostat

there is a chance that the electronic control has gone bad.
but you nee to check the ignitors and see if they are coming on if not check the power from the EOC to the ignitors.

could be clogged try sticking a pin in it before turning it on

F5
- E1 Self clean latch will not
lock

1.
If door latched:

1. Disconnect power from unit.
   
2. Check wires and connectors from control to door switch, then from door
   switch to control. If no damage to wires and all connectors okay, proceed to
   step C.
   
3. Replace door switch.
   
4. Re-apply power.
   
5. Press and hold any key down for 1 minute to clear F5 failure code from
   memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure
   operation is correct.

2. If door not latched:

1. Disconnect power from unit.
   
2. Check wires and connectors from control to latch switch, then from latch
   switch to control. If no damage to wires and all connectors okay, proceed to
   step C.
   
3. Repeat steps A and B for door switch.

3. Measure door switch (door open = switch open small low voltage terminals).
Replace switch if defective.
4. Measure latch switch (unlatch = switch open,
CAUTION - oven light contacts are closed). Replace switch if defective.
5. If
corrections are made in any step, reconnect power to control. Press and hold any
key for 1 minute to clear R failure code from memory. F2 will appear. Press
CANCEL and observe for 1 minute to ensure operation is correct.
6. If failure
remains, disconnect power and replace control.

Note:
Applies to all F5-E... codes.

I believe the Whirlpool Accubake SF362LXTS is electric. Have you checked your fuses? Have you recently cleaned or moved anything underneath that could have unplugged it?