Electric Mobility Invacare Pronto M41 Electric Scooter Power Wheelchair - Page 4 - Answered Questions & Fixed issues
My chair just stopped working
You'll need to describe what you were doing when it quit, what kind of chair it is, etc. Right now, try resetting the circuit breaker and see if that helps, also, check to make sure the joystick is tightly plugged in and all other connections are frimly in place.
1/8/2010 6:35:34 PM •
Electric...
•
Answered
on Jan 08, 2010
•
278 views
Wigwag Throttle Control Pot FREERIDER loose
The spring that applies tension on the wigwag often breaks. After removing the shroud to gain access to the throttle, back off the two allen screws (2mm) and pull off the throttle handles, remove the nut in order to replace the spring. The cost of the spring is about $4.00 compared to the complete throttle at about $250.00.
3/25/2019 7:44:39 AM •
Electric...
•
Answered
on Mar 25, 2019
•
304 views
Voltmeter work. gauge does not work.
Hi it might B you're volt meter a bad connection or the control box is not sending information to the voltmeter. Very hard to diagnose the main problem cheers
7/7/2016 5:53:16 AM •
Electric...
•
Answered
on Jul 07, 2016
•
172 views
Convert off board battery charger to work on rascal scooter
It has been done before, but you will violate the safety to do that and anything that happens with this scooter will be your fault! You will need a female electrical part for an XLR Plug to make it so the Male end from the charger will plug in. after wiring the Female connector and plugging the charger in the scooter will run while the charger is plugged in. This can cause safety problems. I’m happy to assist further over the phone at
https://www.6ya.com/expert/bill_bcbb89783b08c489
7/3/2016 7:12:29 PM •
Electric...
•
Answered
on Jul 03, 2016
•
128 views
Not finding what you are looking for?