20 Most Recent
Electric Mobility Invacare Pronto M41 Electric Scooter Power Wheelchair - Page 5 Questions & Answers
Full set returns once then reverses and comes back
The number of lights that are blinking indicate what the problem is.
Visit this site to locate the type on controller on your power chair and
you will be able to see that the blinking lights mean:
http://www.pgdt.com/scenter/diagnostics/diagvsi.html
Try to reset your manual brake release as this is a common problem.
If you continue to have a problem, contact your manufacturer or dealer
for service. If your insurance purchased they power chair for you, they
may also cover the cost of repairs.
Good luck!
10/20/2010 4:05:03 AM •
Electric...
•
Answered
on Oct 20, 2010
Someone accidently locked the chair now when you
I'm not 100% sure but I think if you push the ON button and keep your finger on it and at the same time press the horn button it may unlock it. Not all models are the same but its worth a try. Good Luck
10/17/2010 2:04:30 AM •
Electric...
•
Answered
on Oct 17, 2010
Charger is going to a green light just seconds
wnorman sounds like a charger problem but if you have a digital voltmeter you can check the battery voltage by setting the meter to 200 v dc and plugging the two leads of the meter into the two outter plug holes of the charger port located under the front of the joystick. Fully charged you should read 24-27 volts.
If you are reading less than 25 volts then you will have to replace the charger. I would ask around for anyone that has an off-board charger for you to borrow for a few hours charge with that charger and see if it makes a difference. If you still get a quick green light from the borrowed charger or when you checked with the voltmeter you didn't getting a reading then there is a connection problem. Hope this helps
9/26/2010 12:39:32 AM •
Electric...
•
Answered
on Sep 26, 2010
Seat back won't lock
JC If your chair is an Invacare locate The lever on the right side of the lower seat cushion that lets you adjust the seat back it might be stuck letting the seat back not lock. Try setting the back where you want it and pushing down on the handle to see if you can get it to lock. If you can't get it to lock you'll just hafta get another seat or find a used seat that you can take the locking lever off of. Hope this helps
9/15/2010 4:14:18 PM •
Electric...
•
Answered
on Sep 15, 2010
We are trying to move the chair and the service
The service light indicates a problem. Count the number of flashes. ie flashes 4 times pauses flashes 4 times etc. If you have the owners manual the flash code section will tell you what the number of flashes mean: 3 flashes left motor 4 flashes right motor. You will have to contact a service company to repair the chair once you find out what flash code you have. If Medicare pirchaed the chair then they will pay for most of the repair cost. Hope this helps
8/25/2010 12:11:23 PM •
Electric...
•
Answered
on Aug 25, 2010
Amber light will not turn to green
mcdevito75 here, Double check all your electric connections, and if the battery is 2 years old or older you may need a new one, old Battery may not be takeing a charge.
6/26/2010 5:44:12 PM •
Electric...
•
Answered
on Jun 26, 2010
My chair just stopped working
You'll need to describe what you were doing when it quit, what kind of chair it is, etc. Right now, try resetting the circuit breaker and see if that helps, also, check to make sure the joystick is tightly plugged in and all other connections are frimly in place.
1/8/2010 6:35:34 PM •
Electric...
•
Answered
on Jan 08, 2010
Hello i have a kymco xl mobility scooter which has
Hi , is it the Midi or Maxi XL model ? PG Controller (normally a silver colour ) has the following as the listed fault There is a bad connection to the motor and the controllerIf 's it a Rhino controller normally a blue colour , The battery is completely empty. The scooter does not drive.• Recharge the battery immediately.If the scooter is left off for a few minutes, the battery may recover enoughto allow driving again for a short time. However, driving on an emptybattery may cause damage to the battery.Regardswww.gewizrepairs.co.uk
3/24/2022 8:52:42 AM •
Electric...
•
Answered
on Mar 24, 2022
Wigwag Throttle Control Pot FREERIDER loose
The spring that applies tension on the wigwag often breaks. After removing the shroud to gain access to the throttle, back off the two allen screws (2mm) and pull off the throttle handles, remove the nut in order to replace the spring. The cost of the spring is about $4.00 compared to the complete throttle at about $250.00.
3/25/2019 7:44:39 AM •
Electric...
•
Answered
on Mar 25, 2019
Not finding what you are looking for?