20 Most Recent
Generac 5622 GP Series GP5000 6,250 Watt 389cc OHV Portable Gas Powered Generator - Page 9 Questions & Answers
How to check a starting capacitor on a generac generator
Disconnect wires and use a Fluke meter 16, typically used by HVAC techs. (It has a capacitor charge function) You cannot use a multimeter accurately. An old analog meter on ohms, will show a reading then decay, all that tells you is it isn't open, it does not tell you if it is holding correct mfd capacitance
3/1/2015 9:23:22 PM •
Generac...
•
Answered
on Mar 01, 2015
How to set up governor for Generac GN-220 motor
The circuit board controller is monitoring the engine rpm and frequency and thus controls the frequency, via the governor actuator, or stepper motor as you say. You can't adjust it. I doubt this is the problem it sounds like either engine is not delivering HP, or there is a stator short causing excessive load / current draw bogging the unit down, incorrect wiring of the stator output. Ha someone taken the stator output leads off the breaker? check the stator resistance and shorts to ground.
2/28/2015 10:53:11 PM •
Generac...
•
Answered
on Feb 28, 2015
Not finding what you are looking for?