Top 20
Swisher 44-Inch 12.5 HP Trailcutter #RTB12544 - Page 7 Questions & Answers
Lawnmower will not move while running
no ibfo generic answer --check drive belt --popped off --broke--pulley problem--trans axle problem ---key way on wheel sxle damaged or missing
9/25/2023 12:52:56 AM •
Garden
•
28 views • 0 helpful votes
Ride on mower coil keeps burning out
Overheating of the engine and faulty ignition coil components, such as spark plugs and cables, are the most common causes of repeated ignition coil failures. If your ignition coil becomes too hot or becomes burned out after a few attempts, the reason may be due to incorrect spark plugs
9/7/2023 12:08:15 PM •
Garden
•
37 views • 0 helpful votes
My Scott's 15hp/42 cruise control riding lawnmower will not move after releasing clutch/ brake
It's a rebranded John Deere. See following URL for parts diagrams..
https://partscatalog.deere.com/jdrc/search/type/model/term/S1642
Check the transaxle drive belt is intact and not loose when brake is released. The belt runs from the top drive pulley of the engine to the back of the unit to power the transaxle.
Owners manual is also available for no fee download on the JD website
9/25/2023 12:33:26 AM •
Garden
•
24 views • 0 helpful votes
Husquavrna Lt1536 not cutting
Remove belt tension and test the tension pulley arm (55) rotates freely and spring (148) is in place. See attachment.
Husqvarna (USA) lists the belt as discontinued and no substitute. I find the belt should be 92.5" in. If measurement is questionable then take the belt with you to a local supplier and compare lenth of old belt to a new belt of known length 92.5".
9/15/2023 9:39:02 AM •
Garden
•
28 views • 0 helpful votes
John Deers Sabre GX1438 transmission issue?
this shows the parts exploded views of drive train -deck-with their pulleys and belts check the linkage at transaxle as well as the pulleys -------------- https://www.weingartz.com/illustrated-diagram/john-deere-parts-lookup/model-sabre-1438-lawn-tractor-pc2675/4275-36038
9/7/2023 12:09:20 PM •
Garden
•
28 views • 1 helpful votes
My GroundWork sprayer won't hold pressure. Water is coming up in the handle.
Question edited for clarity, ' won't ' is a contraction of 'will not', 'the word 'want' is a request for something, they aren't interchangeable. ;>)
You sprayed has two handles, one on the wand and one on the pump.
Replacement wands are readily available. The pump is very simple in the way it works, there is a sealing gasket on the piston in the tube to create pressure and a non-return valve at the bottom of the tube to stop water flowing back. Check that they are clean and not obstructed.
GroundWork Sprayer parts
https://www.google.com/search?q=groundwork+sprayer+parts
..
7/25/2023 8:22:30 AM •
Garden
•
73 views • 0 helpful votes
Not finding what you are looking for?