Bosch WFLI 2440 Front Load Washer - Page 5 - Answered Questions & Fixed issues
Bosch washing machine Logixx 8
Slide a couple of sheet of newspaper under the machine and leave it a while and pull it out. The drips will show the approximate location. Then you can pull the machine out and lean it against the wall to check underneath. Make sure someone is steadying it.
The most likely is a faulty water inlet solenoid valve.
I have a Bosch front load washer, Series 8 9kg WAW28420AU looking how to do a factory reset
I have never heard this before, but worth a try
Resetting your washing machine
- First, you should perform a general reset of the machine. Turn the machine off at the power outlet, wait for one minute, and then turn it back on.
- If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved. If it drains, problem solved!
https://www.hunker.com/13410561/how-to-reset-a-bosch-washer
11/15/2021 6:46:00 PM •
Bosch Washing...
•
Answered
on Nov 15, 2021
•
3,734 views
Bosch Logixx 8, Error F:57.
what does it means?
If there is an f57 error code, in 80% of cases the problem is related to the motor control board. But do not rush to buy a new one for your Bosch washing machine. When you solder the components of the board, they may be damaged as a result of the strong vibrations of the machine. Therefore, you need to monitor the correct and stable installation of your washer. In many cases, an experienced master can bring the device back to life. It will significantly save your budget. Think before you start an independent repair. Remember that the new electronic unit is quite expensive.
9/12/2021 6:19:07 AM •
Bosch Washing...
•
Answered
on Sep 12, 2021
•
1,580 views
Not finding what you are looking for?