20 Most Recent Bosch Classixx WFL 2066 Front Load Washer - Page 2 Questions & Answers

Try this linky: Download instruction manuals

F21 means motor or control board fault. Usually its the motor. If you have replaced the brushes and it doesn't work then its most likely the motor is faulty. Not a cheap fix.

My one beeped every 30 seconds to tell me that the cycle was finished.It should stop itself after about 15 minutes,or just turn the machine off.

go to store and buy washing machine cleaner and run it in your washer and it will smell great again. I think Tide makes it but not for sure.

Have you tried a boil wash ? Also check that the drain pipe has no kinks or sharp bends in it. I know we managed to get the drain pipe cleared :-) But the next step may be to check that the waste pipe you are connecting to is not also scaled up. If you can take the drain pip off again, check and see if the pipework you are connecting to is also clear. Other than that, this may actually be a failing drain pump. Check the rest of your pipes are clear in the house (where the machine is plumbed into). Then do a boil wash - hottest wash you can, NO SOAP and empty drum. Hopefully that will let the machine clear everything else out.

I would check that the drain pipe is also clear. You can actually get a build up of old soap powder in the pipework. This pipe would be on the rear of the machine (grey in colour) and would connect to your waste pipe (perhaps under a sink) If you can pull the machine forward and check to see if this pipe is indeed blocked, or even restricted. I found this answer that may help you. https://uk.answers.yahoo.com/question/index?qid=20120322120919AANhp8H

There should be a filter located at bottom right front of washer.
To clean it ,unscrew anti-clockwise, remove and clean it.
If you cannot see the filter, it may be behind a removeable plastic cover at bottom of washer..
Hope this helps you

Hello when you start the machine do you hear clicking from control board if do all you need to do is replace the carbon brushes on the motor. They are cheap to get does require removing back pannel I found better to remove motor easy access hope that helped :)

check to see if there is any power going to the main board and if not you have a problem with a plugin, but if power going to main board then you have a fuse blowed, ie ceramic fuse.

pull out the plug check the carbons they may be worn

It's very common. There is a high efficiency washing machine cleaner you can use in is as well as cleaning the gap in the seal for the door. Some machines also have a filter to catch small objects and if that is not clean it can smell as well. If you need further help, I’m available over the phone at https://www.6ya.com/expert/justin_3ae27a9d61d6acd4

YOU PROBABLY HAVE THE CHILD LOCK ACTIVATED GENERALLY HOLDING THE LOCK BUTTON IF THERE IS ONE OR THE START BUTTON FOR 5 SECS OR MORE WILL TURN IT OFF ALLOWING NORMAL USE