20 Most Recent Bosch Axxis WFL 2060 Front Load Washer - Page 7 Questions & Answers

You can find the manuals at this linkhttp://www.bosch-home.co.uk/customer-service/download-instruction-manuals.html

Check the filter behind the flap (Bottom right of kickplate) souns like you have a coin or other foreign object in the pump.

If the water flows though the inlet then the flow pressure should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash.

Check this link to replace the inlet valve: http://www.espares.co.uk/advice/washing-machines/a/7/1408/how-to-replace-the-inlet-valve-on-a-washer-dr.html

Please check for tips to remove and replace pump: Bosch.

what you need is washer magic here is the web site click here

Possible error code,power motor problems, Now switch off power , holding the pause/ stop button turn on the power. Now switch off and check once again.

Hi there, i have prepared two links. The first one is the original manual you requested and the second link refers to the quick reference guide.

Click here for the first link to your original manual.

Click here for the quick reference guide.

You Can download the server from the following sitehttp://www.specsserver.com/CACHE/FILE16402.PDF

F43" error indicating "motor malfunction"

I am not sure of the dispenser trays but if the clothes are taking to long to dry and are still damp, check the vent hose and the duct work going out the apartment for lint buildup.

It seems that the main controller could be the culprit but this requires you to counter check and confirm the fault before you can proceed to replace. It will be best to check all the connections and reset the pins and connectors. If the cycle goes through well in many modes it is adviceable to use as much by alternating the cycles than to replace the controller if you can manage..