Oster Golden A5 2-Speed Universal Motor Clipper 78005-140 - Answered Questions & Fixed issues
My Oster Golden A5 Double Speed clipper is not cutting the hair on my dog?
I bought an Oster Golden A5 new in a pet store in 2000. It did not work reliably out of the box- needed constant tweaking of the blade tension screws. It sat on a shelf for 15 years while I paid for many grooming sessions. Over the years I would try to get it to work; in 2015, I bought a generic brand #5 blade from a beauty supply, and it refuses to cut no matter what I do. Today, I spent 40 bucks on an Andis #10 and low and behold it cuts like a dream. Went back to the store and bought a #5 FC and it also cuts like a dream. So all my troubles were caused by 2 blades that were defective right out of the box...
Oster problems. Golden a5 clipper
The blade driving lever is certainly supposed to move, if it isn't then take the cover off and check the cam gear, it's really easy to change it.
Cuircuit diagram pwm
Go to http://www.clipperparts.com/schems/oster/professional%20clippers.pdfYou will find the diagram that you are looking for.
I have just had all the blades sharpened for my
It is common to that a Blade Sharpening Service return your blades just as blunt as before, or even worse.
I advise that you try a new Blade Sharpening Service; trying out only a couple blades to begin with.
I recommend a mobile/on-site sharpening service.
What are the 2 slot
I take it you mean the plastic srews? these are plastic caps behind which are the carbon brushes.
I have an oster a5
Its possible the
gear wheel which is located under the name plate has slipped, if you remove the plate, lever and drive link the gear will pull off.
Inspect the teeth on the gear if there are signs of damage or slipping this is likely to be the problem.
My clipper will not cut
See if the hair is clogging somewhere, do you have user guide? Try clippers for dogs or go to the groomers.
Good Luck
Diana
I have oster 6550 series
the tension should be pre set from the factory, if its more than one blade your having problems with then its likely there is a problem with the clippers.
I have not used my
ok rush can be removed with wire wool or a wire brush and will be prevented by the application of oil.
Grease should be inserted into the gearbox which is located under the name plate, for clipper oil have a look at the
page.
Not finding what you are looking for?