Top 20
Maax Brio II One-Piece Neo-Angle Corner Shower with MAAX IES 1/2 System - 1 - Page 9 Questions & Answers
I have a mq3-45. How do you test the psi on the bladder tank? Or how do you know if it is bad?
First turn the well off. Then run the water until it stops. Then check the pressure. It should have 2 psi less than when the pump turns on. If you have a 30-50 switch it would be 28 psi, 40-60 is 38 psi. Look under the switch cover and it will tell you what it is. If you charge the tank up (which has to be empty) and air comes out of the faucet, the bladder is blown.
8/15/2019 10:15:09 PM •
Plumbing
•
154 views • 0 helpful votes
How do you replace an air bladder in the back of southern motion recliners?
Replacement parts are ordered through the retailer from which the chair was purchased. The warranty, a year for servicing, is also serviced via that retailer. The manufacture does not sell directly to the public. There is a wee chance they might provide a replacement part if contacted directly but likely decided on a case by case basis. There are no instructions posted that I can find detailing how to replace such in a chair. As upholster affiliated with the retailer may have direct knowledge for this product line.
All that said, perhaps something on the following page may be of assistance to you.
https://www.amazon.com/Sports-Imports-Seat-Lumbar-Bladder-Universal-Inflatable/dp/B00F5272FE
Alternatively, here is contact information for the manufacturer. Bare in mind they do not engage in direct sales to consumers.
Customer Support Phone Numbers
Phone:
+1 662 488 9301
5
6
Web:
www.southernmotion.com
Mailing Address
P.O. Box 1064, Pontotoc, MS 38863
8/14/2019 6:24:33 PM •
Plumbing
•
157 views • 1 helpful votes
Kitchen faucet mount comes loose
Sounds like the nut attaching faucet under sink has loosened. You have to crawl under sink to tighten it.
7/11/2019 12:22:23 AM •
Plumbing
•
196 views • 0 helpful votes
Tub spout has low flow or water pressure
If this a new circumstance it could a few things causing. If the spout has a button on it to divert water to shower, it is probably a blockage in nipple. Just remove spout, clean all debris buildup. If you have a diverter valve (Handle) it's most likely blockage in valve. This is assuming shower pressure is normal.
7/7/2019 10:20:06 PM •
Plumbing
•
196 views • 0 helpful votes
My kitchen does not have hot water
Does it run cold? Or not run at all? If cold and bathroom hot, it's piping problem. If doesn't run, valve closed. If no hot water anywhere but runs cold, water heater problem. If gas, fire out.
7/6/2019 2:11:45 PM •
Plumbing
•
182 views • 0 helpful votes
Not finding what you are looking for?