Question about OEM Systems Vehicle Parts & Accessories
...1997 Key Fob How do I program my remote control Fob for my 1997 GMC Yukon 1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4. (Notice port ...
car with the viper remote start 785 xv model If your remote starter has a red bit writer/expresskit port then it has the ability to add a smart start (DSM 200/250) to the system
Question about Chevrolet Vehicle Parts & Accessories
...or the cable? If you pull the radio carriage out you should see a cable plugged into the antena port of the radio. If this is plugged in check the cable up to the ...
...the remote to show any charging indication. Otherwise the charger is bad ( can be charged on a usb port of a computer if you have a mini usb cable) or the battery has failed and will need to be ...
...between the engine and the trans. Also could be the intake manifold gasgets. It could be the heater port on the intake(front right of intake) that runs along the top of the intake and then off the ...
...car starter and only my dash lights go on then shut of 3 times without my car turning over. The key port is also locked. It sounds like the bypass module is not bypassing. The next time that you ...
Question about Viper Vehicle Parts & Accessories
...toggle switch. The switch then has a black wire that should be connected to...? There are only two ports on this older Viper 300; the main harness port and one port on the side for the lock/unlock ...
Question about Autopage Vehicle Parts & Accessories
...but cannot control it from either device? You will need to verify the DATA cable is plugged into PORT B on the main unit. This is essential for correct communication between the 730 and the C3
...have to reflash the ECU. You will need to got to Halfords or any shop that has it. Then locate the port under the steering wheel. turn the car on and it should
510 questions posted
Usually answered in minutes!
71 Questions
51 Questions