the starter with a plastic hammer, and the starter works, you need starter brushes. If you open the starter and the armature is shorted or the coils are grounded or burnt, replace the starter assembly
...Starter is not requesting power so lite stays bright.Don,t forget to check ground wires at battery and frame.You changed battery check connections. My 2004 VTX 1800C will not crank. It was cranking ...
Question about Honda VTX 1800 Motorcycles
...hitting the kill switch its a 2004 suzuki Intruder 2004 1500vl? sounds like a stuck starter solinoid ! replace it ! I wired my bike starter and senolid when starting starter keeps winding won't ...
Question about Honda VTX 1800 Motorcycles
starter removal on 2004 ultra classic harley davidson starter removal on 2004 ultra classic Disconnect battery , remove the outer primary case, pull back the lock tab on the starter jackshaft, unbolt ...
...2004 Yamaha VStar 1100 that turns over hard but starts and runs, it is not low battery or bad starter, already checked. It sounds like your starter might need new brushes or replaced. I would start ...
Question about Honda VTX 1800 Motorcycles
...starter off a 2004 harley sportser Disconnect the battery, and remove the rear exhaust pipe. On the left side, you'll have to remove the outer primary. Just above the clutch assembly inside the ...
...2004 Harley Davidson 883 Sportster will not start. in the past year I have replaced the starter, battery, and wiring for starter. clicks but no turn over of motor. any ideas? With just this info.Not ...
Question about Honda VTX 1800 Motorcycles
2004 Yam VStar 1100 motorcycle-starter spins but will not engage When a teen- had similar problem-replaced solonoid and car started. My manual and electrical diagram do not indicate a solonoid; ...
Question about Honda VTX 1800 Motorcycles
...replace a starter on a 92 evo softtail heritage Disconnect the Battery, so theres no power. Find the replacement starter, remove the bad starter(remembering the wiring) and replace with new starter. ...
starter will not disengage Hello, So your starter is stuck you will have too loosen the starter and might even have too remove and put it back on too get it too disengage. Sounds like starter is going
52 questions posted
Usually answered in minutes!
56 Questions
22 Questions