Question about Generac Electrical Supplies
...one or both of them are probably blown. N1 N2 fuses have the yellow wires on them if they are blown the generator thinks there is no utility power and will start There needs to be 220 volt on them
...is a blown N1 or N2 fuse in the transfer switch. If you are not comfortable working on 240 volt power supply, please call a certified electrician to test and replace the fuses in the transfer
Question about Generac Electrical Supplies
...protection fuse(s) for the sense lines from the utility. That is the first place to check. your sensing fuses in the transfer switch might be blown. pull each one out and check them with an ohm ...
blown fuses and/or damage to the control board in the generator. the 4 wire you have in the cable are utility sense and the start circuit. the two extra terminals that you are talking about are likely
Question about Kohler Electrical Supplies
should have two wire remote Start/Stop. It may need to be shortened in order to start. If the engine does not turn over check for the obvious , dead battery or blown fuse or fuses on the control board
...fuse was blown at T1 in the transfer switch. When the fuse was replaced the display showed low battery. Battery is brand new purchased the day installation was complted. Battery was charged and after ...
Question about Generac Guardian Electrical Supplies
generator for charging system? Most battery chargers are trickle type chargers - that is, they provide a constant low current (under an amp) output at 12 - 15 volts to keep the battery charge up.
35 questions posted
Usually answered in minutes!
58 Questions
2 Questions
