Question about Saturn Ion
is bad, or power is not reaching it. May have to pull the pump connector off at tank, and check for 12 volts on pump wire when someone cranks the car. If power there, the pump must be bad. If no power
Question about Cars & Trucks
...12 volt system. looking for a basic 12 volt wiring diagram for GM alt. and wisconsin parts? Tow motors model No. YT40. Hyster 40. Serial no. 35843. Wisconsin Air cooled 4 cylinder, Model no. VF4. ...
...12 volt range if Alternator faulty. If ok would be 14 volts approx. Assuming battery voltage low. First remove negative battery terminal and proceed to take of drive belt by taking strain of belt by ...
Question about Cars & Trucks
...replace the head lights with a basic pair of fog lights The easiest way is to use a 12 volt test light. Turn the lights on unplug them, ground the test light clamp and probe the connectors. Good ...
...wiring on each of the speakers,and match them out to the ones on the clarion.the most common colr code is white front left,gray front right green rear left and purple rear right.each speaker has a ...
Question about Cars & Trucks
WIRING DIAGRAM BECAUSE PREVIOUS PERSON WHO WORKED ON CAR TAPPED IN TO THE DISTRIBUTOR WIRE Kinda hard to post a hand drawing, but basically the wire to the the distributor comes from the coil terminal
...volt meter on the car,and check the voltage while the car is running.It should read about 13.65 to 14.25 volts.If it is less than this ,the alternator is not putting out enough voltage,or none at ...
12 volt test light & probe wires in harness from original connection, on feed side .Find a wire that only has power when you turn the key on. That's the one you'll connect that wire to. check this web
...wiring diagram for my 1977 dodge melmar fargo f40 rv The ignition circuit should be the same as any 1977 Dodge truck, which is basically battery to ignition switch, start side of switch bypasses ...
...wire connector and use a volt meter or simalar device and check if the wire has 12 volts when you have the fan turned on, if yes, then the motor is shot, if no then you may have ablown fuse or ...
1,037 questions posted
Usually answered in minutes!
581 Questions
541 Questions
394 Questions
148 Questions
73 Questions