2000 Kia Sephia "sensor inlet manifold" Questions

sensor and how do I fix it? In the exhaust converter inlet or pipe before it for all upsteam sensors On some small engines like a 4 cyl they are in the exhaust manifold near the motor Most sensors use

sensor, check brake booster line for leak. Check for air leaks around manifold ports (gasket area ) check all vacuum hoses , you can check for air leaks by spraying WD 40 around the inlet ports and if

sensor may be attached directly to the inlet manifold, it will have a inlet which sits into the manifold approx 1/2 an inch to measure pressure or it may be mounted away from the manifold on the inner

...sensor). The code you mention states: P1471 Land Rover Variable inlet manifold motor 1.Short circuit to V Batt. (vehicle battery?). P1472 Land Rover Variable inlet manifold motor 2.Short circuit to V ...

...sensor [2] from inlet manifold[5] 4.Remove O-ring seal [5] Installation procedure: 1.Clean and replace worn out components. 2.Install a new O-ring 5 to boost pressure sensor [2] 3.Install boost ...

...and one for lo volts, check all your wiring and the connector on the Twinport Position Sensor. This can also mean e replacement inlet manifold. The wiringconnector is underneath the inlet

...engine. But basically you need to remove all inlet tract components, and the top cooling system components, then remove inlet manifold and there you will see the knock sensor. Good Luck Thanks ...

...Sensor Circuit Malfunctionsounds like you could have a breather pipe from the engine to the inlet manifold playing up from them codes ,now remember i have never seen a petrol version of this vehicle ...

2008 kia rio5 1.6 engine can't locate the map sensor Should be right there on the inlet manifold or inlet trunking between airbox and manifold.

Cylinder 1. Sensor one is always the O2 sensor before the CAT or inlet side of the CAT. Bank 1 Sensor 1 is also called The Upstream sensor. This sensor screws into the exhaust manifold, before the CAT