...high pressure is built into the feeder line (relieve valve stuck?? hoses or drive-rack blocked??) YOU CANT USE A REGULAR FUEL LINE ON POWER STEERING AS A HIGH PRESSURE HOSE.BECAUSE POWER STEERING ...
...Install new o-ring on high pressure fitting. 19. Place new pump in position while sliding on low pressure hose. 20. Loosely attache high pressure fitting. 21. Tighten pump to mounts. 22. Tighten high ...
...high pressure power steering hose on 2004 Monte Carlo SS. Need tips to effectively do the job myself. Tools needed, tricks to make the job easier, what not to do...etc. Thank yiou so much Dave Lester ...
...Install new o-ring on high pressure fitting. 19. Place new pump in position while sliding on low pressure hose. 20. Loosely attache high pressure fitting. 21. Tighten pump to mounts. 22. Tighten high ...
Question about Buick Cars & Trucks
...high pressure side then it will have metal connections on both ends. The rubber hose is the low pressure side. Follow the hose with the metal ends and you’ll find your answer here is a site with pics ...
...HIGH PRESSURE LINE FOR A POWER STEERING UNIT ON A 1998 MUSTANG? Disconnect battery ground cable. Remove engine Air Cleaner (ACL) . Disconnect electrical connector in back of engine cooling fan motor. ...
...Install the high pressure fluid line to the pump output fitting. Torque the high pressure line-to-power steering pump fitting to 275 inch lbs. (31 Nm). Be sure to inspect the pressure line O-ring for ...
...high pressure hose?<-You Ask. NO Not on the 95 and If you do need or want to REMOVE the PUMP it Comes off Without the Removal of P/S Pump Pulley. Now if you are replacing the P/S Unit Yhere is A ...
Question about Acura Cars & Trucks
...high pressure power steering hose? It's not that hard to do. Start at the pump and remove the end of the hose. It's bolted to the pump. Follow the hose down the frame and remove the bolts holding the ...
dodge durango is leaking at the high pressure fitting it is tight. The pressure hose is leaking due to forgetting to install the o-ring. You should disconnect pressure hose install o-ring then tighten
247 questions posted
Usually answered in minutes!
276 Questions
128 Questions
134 Questions
125 Questions
115 Questions
