1997 Mercury Sable "throttle body 2000" Questions

Ad

Question about Mercury Sable

1 Answer

...still can't find it...please anyone??? Look on the intake manifold there will be a 3/8 hose attached to it going to the throttle body or the air intake tube that attaches to the throttle

Ad

Question about Mercury Sable

1 Answer

...on my 2000 mercury sable? look on the backside of the engine near the firewall. Slightly under behind the intake plenum where the throttle body is you will see the dipstick near the coolant

Ad

...posible trouble codes stored in the PCM that could be related to a faulty engine managment component. You may also try to spray out the throttle body with intake cleaner and inspect the spark

car and put gasket maker on top of the gaskets and also found oil in the throttle body to and very little on a spark plug please answer quick thank you check the PCV valve and system for being plugged

Question about Mercury Sable

1 Answer

of the engine, you will need to remove the air intake piping (Also remove the throttle body to make accessing them easier) This is the #1 cause of high idling in the 3.0 OHV and 3.0 DOHC sable engines

...throttle body, two new ignition coils. After a few minutes rough idle goes away. Sometimes causes check engine light to go on. Not consistent problem Sounds like you might have a bad engine coolant ...

...in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the

Question about Mercury Sable

2 Answers

throttle body and the air filter p0171 is a lean code that can be caused by the maf sensor but also by vacuum leaks and low fuel pressure Hi Friend: Your Mass Air Sensor is Located on the Back Side of

...throttle body(inside of it, use a tooth brush and brake clean) and spray the mass air flow meter(located by the filter on the air induction tube). A lot of times this will take care of sputtering. If ...

Question about Mercury Sable

1 Answer

...throttle body remove all electrical parts also all plastics and rubber parts.clean throttle body with gum out throttle body cleaner.dry off throttle body.replace gasket.scan it to check to see if egr ...

Not finding what you are looking for?
1997 Mercury Sable Logo

770 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...