...oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter Removal & InstallationDisconnect the negative cable from the battery. Raise vehicle on hoist. Remove front splash shield. ...
...oil pressure sender connector (4). Remove the pressure sender (2). To install: Install oil pressure sender. Connect oil pressure sender wire. Install front splash shield. Lower vehicle. Connect the ...
Question about Jeep Grand Cherokee
...oil pressure guage is there a sensor or vacuume line that could of worked loose where would it be located at Location of oil pressure sender unit depends on what engine you have. There should be one ...
...oil pressure gauge at zero. Oil at full on stick? Sounds like you have a bad oil pressure sending unit, the oil pressure sending unit controls your oil pressure gauge, what I would do is remove the ...
oil pressure gauge is on 0 even tho i do have oil pressure nd the jeep is running fine. how do i reset the oil gauge to start reading the pressure correctly again? Thank You I would start by obtaining
Question about Jeep Grand Cherokee
...oil pressure sending unit switch 4.7 l engine location of oil pressure sending switch on 4.7 litre engine its next to filter. the sender fits to the main oil gallery like the filter too. why not just ...
...oil pressure sender on a 4.0 liter it is located on the passenger side rear of the block, It's on the right side of the vehicle. (If you're in the States the sender is on the passenger side of the ...
Question about Jeep Grand Cherokee
...oil pressure. Do I need to replace oil sensor and where is it located? Oil pressure gauge is up to 80. You could start with the sending unit. Could be a wiring problem or it could actually have high ...
Question about Jeep Grand Cherokee
...oil pressure switch (or pressure sender,if you have an oil pressure guage).Two of my Chrysler products have done this.Replace the sensor, and if it's not too hard to get at,take the connector ...
oil pressure down to 0 Obvious question: Is the oil in the engine full and is the engine making any noise? If the oil is full and not noisy, likely the oil pressure sending unit has failed (usually ...
3,696 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions