Question about Cadillac Catera
...intake manifold on a 1992 Oldsmobile Cutlass Ciera s v6 3.3 liter Hi,with the inlet manifold as long as the two serfices are clean and the gaskets are being replaced,all you need to do is tighten all ...
...intake manifold off but wont come off. we have loosened every bolt. any suggestions? thanks.. According to what I can find, you don't need to take the intake manifold off: 3.5L Engine Disconnect ...
...intake manifold gasket on 2000 Chevy Blazer and now truck wont start hi, its sounds to me like the gasket could have been faulty unless a wire has come off or not fitted properly, Check for loose ...
...intake.under the water inlet housing. if its bad it wont close, if it doesnt close the water doesnt stay in the engine block long enough to heat up. if your a do it yourselfer remove the upper hose ...
...intake manifold. Make sure all bolts/nuts are tightened securely and all vacuum hoses are conected and in good condition. 3.Leaking EGR valve or pluged PCV valve 4.Fuel pump not deliverying enough ...
...intake manifold with a new gasket. Install the water outlet to the intake manifold with RTV sealer. Tighten the attaching bolts to 20 ft. lbs. (27 Nm). Connect the radiator hose to the water outlet ...
Question about Cadillac Catera
...intake manifold and other contraptions like the throttle/cruise control cable and 4 inch air intake tube. If you have engine work experience, great! If not, color code every disconnect then match up ...
...is this a 4 cyclinder our a 6 cyclinder if it is a 4 cyclinder its under the intake manifold pointing towards the trans. if it is a 6 cyclinder it will be on back of the mtr closer to the fire ...
...intake manifold, disconnecting the 2 rubber hoses to the heater line. You may also need to disconnect the fuel line. Remove the exhaust crossover heat shield and loosen the crossover pipe from both ...
...surfaces of the intake manifold or throttle body.,Make sure all mounting bolts/nuts are tightened securely and all vacuum hoses connected to the manifold are positioned properly and in good ...
349 questions posted
Usually answered in minutes!
465 Questions
351 Questions
270 Questions
166 Questions
2 Questions