Question about Jeep Cherokee
...to fast. Idles at 1600 rpms in gear and 2000 rpms in park and idle. Have tried the idle stop and the throttle position sensor. What else can we try? Idle bypass screw adjustment or idle steper
idle adjustment screw on the choke linkage that controls engine speed while the engine is warming up. The tip of the screw rests against a cam that slowly rotates as the choke opens during engine warm
...idle to fill the rad. and when i tried to bring up RPM's it would bust out like intake AND exhaust valves were open. good compression on all cylinders replaced almost everything except flywheel and ...
new rebilt carter yfa installed, but idle at 3k all adjustment screws backed out, ? the 2.5 L 4 cylinder came from P O with a jury rigged rochester carb of 77 ford vintage, hard to start so I got the ...
...idle screw a bit, but doesn't seem to help. I listened under the air filter and I can hear a hissing noise. Could it be a vacuum that I didnt connect properly, or something else. Next step will be to ...
Question about Jeep Cherokee
...adjust the TPS for 0.26 volts at minimum throttle opening (idle) worst case: the FSM says it auto calibates if the new TPS errors,. set it to 1/4 volt at idle. reset ECU , all DCTs using scan tool ...
...screw for engine idle speed, later models did away with the enrichment screw, to adjust set idle screw to 600 rpm, adjust air mixture screw to fastest rpm , reset idle screw to preferred idle
...screw for engine idle speed, later models did away with the enrichment screw, to adjust set idle screw to 600 rpm, adjust air mixture screw to fastest rpm , reset idle screw to preferred idle
Question about Jeep Cherokee
...Adjust idle RPM for a 2003 honda accord. some people were talking about a screw on the throttle body. but I can't find that screw. How do you go with adjusting this and where to find it ? How to ...
...gage. If your Idle is too high you may get after run or knocking. I would set the timing then adjust the idle afterwards. I hope this helps out since I do not know if the carburetor is stock or
723 questions posted
Usually answered in minutes!
1,380 Questions
1,162 Questions
698 Questions
672 Questions
659 Questions