...fluid from the frost plug, now my motor has a block heater in it I was wondering when I order a new frost plug if there is two kinds of them or do I order just a frost plug and then put the block ...
...fluid was not working.i put toggles in for wiper/washer but that night driving turned headlights on and the truck shut off. i turned the lights off and it refired up and drove soso.ive since tried ...
...Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) . Top of the coolant reserve tank Let it ran for 10-15 minutes. Monitor for air pockets ...
Question about Jeep Wrangler
...put it in reverse or drive. It will start up again right away. It won't stall if you keep your foot on gas as you shift into the gear. It never stalls when driving. It has been used for snowplowing. ...
...fluid and run fresh water though it. I usually leave the drain plug out stick the garden hose in and let the water run with engine off till it comes out clean. But what you should do is empty it. put ...
...radiator) and replaced the fluids but still cold air) Help Me Please replace termastat Did you drill by the passenger side to put mud guard? I did drill into the vacuum reservoir, and it went into ...
fluid should have dropped down in the radiator add coolant itll full you may have to keep adding depending on how much air is in the system put cap back on and turn vehicle off that is how you bleed a
...radiator fluid it always seems to be missing some, I have to add fluid once in a while, but i have tried looking for the leak and can't seem to find it. I have a 2002 Jeep Wrangler X! I would suggest ...
fluid immediately. There should be a fill level mark and yes you need to put in immediately, run the car until it reaches operating temp, then see where the level is after you shut it off. Well you do
383 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions