2002 Jeep Grand Cherokee "brake caliper sticking" Questions

...brake and have manually opened calipers. After sitting for a few minutes they gradually release but if brakes are applied they stick again. First you must look closely at the caliper and determine if ...

...caliper, brake hose, front pads, rotors, and had a complete brake system flush. What is causing this one brake to stick...all other brakes are ok. Check rubber brake hose at caliper and replace if ...

brake line has been replaced. what may be causing the brakes to overheat and smell? It sounds like the caliper slides themselves are sticking, remove your caliper and check that the caliper slides are

Brake caliper or brake hose? My truck just started shaking and pulling to one side. When I parked the passenger side rotor was so hot I could fry meat on it. Mechanic told me he thought it was the ...

brake hose from the caliper. 7. Again using a c-clamp and pushing straight in: Try again to repush the caliper piston back into the bore without the hose attached. If it goes back-in relatively easy -

...brake caliper that is sticking which would cause the brake to stay "on" and overheat the brakes or you could have a wheel bearing that has failed and is locked up but they usually make some noise ...

Once I saw a broken brake caliper bolt and when the brakes were applied the caliper shifted up and ground into the rim just like your seeing...just take the wheel off and investigate its not that hard

brake pad replacement no identification of make on calipers except mopar symbol black caliper and black caliper bracket = ATE (Teves), the other color is Akebono. To replace pads, use a screwdriver to

...BRAKE GETS VERY HOT SMOKES. CHANGED BRAKES AND ROTORS BOTH SIDES NOW OTHER SIDE DID IT. wHAT MAY BE CAUSING THIS/ Were the calipers check for not sticking, as well as lubed well when re-installed? If ...

...caliper piston that sticks sometimes? if the check good then look at your rubber brake line could be internally damaged not letting the presure return fast enough to the master cylinder? but most of ...