2001 Jeep Wrangler "remove bolts oil crank case" Questions

...oil pressure, or??? the PCV is a crankcase device. it is easy to remove. why not tell the story of why you want to find a part . eg: my buddy said I need to change the PCV at tune up. or my oil light ...

REMOVE THE BOLTS THAT ATTACH THE OIL PAN TO THE ENGINE AND REMOVE THE OIL PAN.CLEAN ALL GASKET MOUNTING SURFACE.APPLY A 1/8 INCH BEAD OF SILICONE SEALER ON THE OIL PAN MOUNTING SURFACE.INSTALL THE OIL

...oil seal on 1966 jaguar s-type 3.8 remove front crossmember remove sump remove crank pulley prise cone from end of crank remove key from crank carefully prise out seal runner checkthis for wear and ...

...remove oil drain plug you need a funnel also.you need first start engine let it run for 5 minutes to warm up thin out the oil so it will flow better.once engine warm up.turn off the engine.open ...

Remove the oil filter adaptor. 3- Remove crankshaft sensor electrical connector. For specific CKP sensor identification. 4- Remove the crankshaft sensor retaining bolt. 5-Remove the crankshaft sensor.

...bolts (RTV, blue or orange color lock tight, if so remove bolt put RTV on bolt and reinstall it(if you decide to use lock tight do NOT use red the bolt will not come out ever again, make sure you use ...

...bolts. DO NOT remove excess material after assembly. DO NOT strike rear cap more than 2 times for proper engagement. Clean and oil all cap bolts. Install all main bearing caps. Install all cap bolts ...

...remove bolts but it wont come off am i missing something need to grt to thr rods sum pans on original engines are glued on at the gasket. You may have to use something like a wood chisel to break the ...

...bolts. 8.Remove all three belts. 9.Remove oil filter and you might as well drain the oil too. 10.Remove crank pulley. 11.Remove upper (1 center nut) and lower (2 side bolts) harmonic balancer shroud. ...

remove. Spray the bolt with penetrating oil and allow it to soak overnight. Book forgets to see CCW direction on bolt (RHT) the bolt will take about 200fl/lbs of reverse torque to get off. 5 Carefully