2001 Jeep Grand Cherokee "changing oil pressure sensor 2000" Questions

oil pressure drops after worm up oil pressure drops to 0 after worm up no kn0ck i v changed the pressure sensor let vehicle reach normal operating temp. remove oil pressure sensor replace with manual ...

...oil pressure transmitter 2.7crd position of oil pressure transmitter 2.7crd (Mercedes engine) Can anyone tell me were the oil sensor is on the 2.7 crd or pictures Have same problem pressure up and ...

oil pressure at idle only low at idle Oil pressure sensor bad, oil pump weak, Could be the sending unit. If you replace it also clean the hole it sets in. The hole can clog up. Use baling wire and run

...oil pressure guage on my 2000 Jeep Grand Cherokee is registering 0. My oil was just changed and I don't see any indication of oil leaking anywhere. Could it be the sensor? First off I wouldnt drive ...

...Oil Pressure is good at 600 rpm. Gauge drops to 0 in 2/10 mile as rpm increases to 2000. Warning light and bell comes on. Gauge varies between 0 and 40 depending on rpm's. After 5 miles Gauge reads ...

...oil pressure guage needle goes all the way past 80,and stays there..while engine is running..then goes back down when engine is shut off..what could my problem be? sounds like the oil pressure sender ...

...oil pressure sending unit is a small device that screws into the block, usually closely related in position to the oil filter. Because it's electrical in nature it will be connected with a two ...

...oil pressure sensor. Does it Need to change the oil pressure sensor. Does it take a special tool and I need the steps. I read someplace about disconnecting the coil wire and cranking the engine first ...

...oil pressure remains the same does not drop stays above normal one mornning you start it its there maybe the next day its not has been doing this for a year and a half doesnt get worse driving me ...

...changing to mobile1 synthetic New oil has a higher viscocity and will read higher than the old oil, especially right after change because the oil is not hot yet. also, was it a different weight and ...