2000 Jeep Grand Cherokee "replacing crank positioning sensor 4" Questions

Crank sensor is generally located on the bellhousing 11 o'clock position looking from the rear. It is always even with the flywheel as it gets it's trigger from that. It is not easy to reach it but it

...crank it again right away it will not light up again, even for a second. So if there was a bad part, im thinking there would not even be a spurt of electricity going to the coil, ever. I read on here ...

...sensor. If the check engine light does not go out while the engine is cranking then you probably have no crank signal. It is located on the left side of the bell housing near the rear of the engine ...

...4 small bols and lower front end of drive shaft. About a 45 - 60 minute job for shadetree mechanics, like myself, and 2 coffee breaks. Prior syptoms of sensor going bad is engine rumbling real bad ...

...Then check and see if you lost spark, if no spark then follow trouble shooting guide for that, odds are you will be replacing crank sensor but could be other things. Process of elimination. Good ...

replacing the crankshaft position sensor solve this problem and do I need to replace the fan relay switch? Thanks! Glenn Yes, most probably a new crank position sensor will solve your stalling problem

crank position sensor, alternator, and have tested with another coil. Can I remove the icu and take it to a dealer to get tested or do I have to tow it in? Is there something else I can check before I

replacing many things and nothing has fixed the problem. Any suggestions? The issue lies with any of the following three things 1) can sensor 2) crank sensor and 3) ignition coil. Check the quality of

...crank sensor (these were new and not breaker yard finds?) 2) Coolant temperature sensor - if faulty the ECU might not make the start up mix rich enough for ignition at cold start up. 3) Idle air ...

...crank positioning sensor and how do I replace it? On the VM 3.1 engine The crankshaft sensor is hidden down behind the turbo . you will have to remove the heat shield and the 2 heater pips and a few ...