2000 Jeep Grand Cherokee "replace oil sending unite" Questions

... OIL SENDING UNIT IS LOCATED NEAR THE OIL FILTER.REPLACE IT YOU CANT CLEAN THEM. Sending unit is located above the oil filter on passenger side. Just need to replace it. Mine went bad at 118k miles

...a timely manor. These deposits can clog up various internal passages , like your oil pressure sending unit. Oil pressure sending units are usually inexpensive and easy to replace. Hope this helped ...

...oil pressure on your gauge then replace the sending unit, if you have a low reading on the gauge stop your engine immediatly and start looking at a potenial problem with your oil pump or lubricating ...

...oil pressure sender only, rev the engine and watch the ohms reading, which should fluctuate slightly (within the range of 15-80 ohms) as rpm increases.If the above results were not obtained, replace ...

...is no engine noises then the oil pressure sending unit is the problem.Just replace it and you should be good.Hope this helps.Good luck. sending unit orbad ground on unit or oil pump is starting to ...

...oil pressure sending unit has gone bad and needs to be replaced. On the 4.7 V8 it is above the oil filter, you'll see the wires going to it. Your going to need to use a 1/16" deep socket for the ...

...oil pressure sending unit is a small device that screws into the block, usually closely related in position to the oil filter. Because it's electrical in nature it will be connected with a two ...

oil pressure sending unit. I replaced the sending unit and corrected the leak but the oil pressure gauge now drops to no pressure when excelerating. The pressure is fine at idle. Any thoughts? Was the

...install a mechanical pressure gauge to verify actual oil pressure. If that checks out good then I replace the sensor. Oil in the connector for the sending unit is a good indicator that it is

...REPLACE A SEAL ABOVE THE OIL FILTER AND NEED A SPECIAL KIND OF WRENCH, DO YOU KNOW WHAT KIND OF WRENCH IT IS. A BUDDY THINKS IT IS A HEX BOLT You might be looking at the oil pressure sending unit in ...