Question about Jeep Grand Cherokee
...line to the fitting at the radiator will not hold without leaking. Is it supposed to have a gasket between the fittung and the tubing? There should be a small o ring, likely got damages or
...runs hot Is the fan working properly? Is the radiator flowing correctly? Does the rad cap hold the proper pressure? check heater core also when unit comes up to corect temp is radiator
...radiator. 2.remove the bolts that hold on the fan shroud there is usually 4 bolts. 3. move the fan shroud towards the engine and now remove the radiator hoses be carefull with the lower because there ...
how to flush the radiator on the radiator there is a bolt on the the bottom of the radiator,u must unscrew it ,this is point to service the radiator,well you have already unscrew that bolt the water ...
...radiator in my 6 cylinder with a/c Not really that difficult..... Unfasten the screws that hold the shrouds for both fans. Remove the electric fan and just push the other one back out of the way. ...
radiator fan relay is located under the passenger side head light,you will need to remove the grill and front bumper cover and of course the head light assembly,there are a few screws in the passenger
...hold the housing (you may have to loosen the belt to get to one of the bolts). Remove housing and replace themostat and gasket ( remove any excess gasket that may have been left over ). THE DETAILED ...
...hold radiator in that go through the grill through the support to radiator you just about have to pull radiator both hoses,shroud but not the transmission lines just lift rad up high enough to get to ...
...hold the radiator in place but the condenser moves with it and those tubes are in the way. I'd appreciate your help a lot. Thanks My info showed a spanner wrench to hold it. I can't see anything from ...
4,475 questions posted
Usually answered in minutes!
3,350 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions