...Changed cam sensor and checked wiring. what else could be wrong? Jeep cherokee, 6 cil A code P0340 could mean one or more of the following has happened: ?a wire or connector in the circuit could be ...
changed the timing belt after the car completely stopped. It had a code p0340. It appeared to me that the belt had slipped a cog. After replacement it still doesn't work. I have replaced this once two
...Timing Belt, why does Check Engine comes on, and it shows Troubleshooting P0340. Symptoms Symptoms can include: Hard starting or no start Rough running / misfiring Loss of engine power Causes A code ...
...car cut off. While they are in there if you need to have the timing belt replaced have them do that too, you save almost $ 300 bucks and its like getting one for $100 and some change. Hope this
...changed the sync I marked the position of the old one and even put the special tool on it and it lined up perfectly with #1 piston at TDC. So where do i go from here? all ways turn the motor over a ...
Question about Chrysler Cars & Trucks
...changed Camshaft Sensor still can't start Oil Pressure light still on. Pull the top cover of the timing, check the belt. Did u make sure to pull negative battery cable before servicing? If not do it ...
...changed plugs,shaking lessened and car runs slightly better. took to auto zone had tested code P0344 possible problems cam sensor defective, timingbelt/out of trime, cylinder misfire...also another ...
Question about Cars & Trucks
...timing belt and water pump and check eng light is on codes are p0345 and p0340 how bad is this and how far can I drive it P0345 and P0340 are "Camshaft Position Sensor" problems. Hopefully it is only ...
Question about Nissan Cars & Trucks
...changed the camshaft sensor and the crankshaft senor and it still wont start and it reads the p0340 code again Please understand the fault code you have, it doesn't mean the sensor is defective, many ...
changed the timing belt in my car, after the the check engine light on, i checked it to have the error codes: P0340 & P0130 any help why i have these errors? P0340-cam position sensor malfunction
4,475 questions posted
Usually answered in minutes!
3,350 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions