2000 Jeep Grand Cherokee "brake pedal switch need adjusting" Questions

...brake pedal,it works the lights each time the pedal is depressed, it may need adjusting or replacing,or it may have come off its mount. If the wiring is ok and fuses also check the bulbs. next step ...

brake pedal does not come back far enough to hit the brake light switch. Is there a way to remedy this? Thanks You can adjust the switch by putting your thumbs on either side of the switch plunger and

brake pedal near the top of its arm (not always as easy as it sounds - you might need to get into an awkward position to see!) There should be a push switch on the pedal mounting that gets operated by

...WORK...BACK DIRECTIONAL LIGHTS WORK...BACK-UP LIGHT WORKS....ALL THREE BRAKE LIGHTS DO NOT GO ON WHEN BRAKE PEDAL IS EXERCIZED. probably the switch at the brake pedal needs adjustment or

brake pedal is sticking and will need replaced. check for a faulty brake pedal light switch, located at the brake pedal up at the top. sometimes there is an adjustment that can be spun back. more then

...If the brake lights remain on without the pedal being pressed, something is wrong with the switch, located under the dash, along the pedal arm. This switch may need adjustment or

...brake pedal is attached to, and held on by a bolt & nut. Disconnect any plugs or wires attached to it, and remove the mounting hardware. Replace the switch, reconnect hardware and wiring, and you ...

...no brake lights, and you've checked the fuses and the bulbs then, the problem is likely a the brake light switch on the brake pedal arm. The switch needs to be adjusted or replaced. Hope this

Rear running light is operational except when brakes are applied the brake light does not illuminate Check brake light switch on the pedal . It may need an adjustment.

...brake pedal assembly in your car. Try lifting the pedal up and see if the brake light goes out. If so, it may be a simple adjustment to the switch, or you may need to replace the switch. Check with a ...