Question about Jeep Grand Cherokee
...ball joints,sway bar bushings and link kit but noise still there...any ideas? wow, is it 4wd? or 4x2.? why not get a , shop find it a person that can hear, and lever parts. and find excess play. and ...
...Ball Joint Keith, I read you write up on the rear ball joint on the WK. I beleive I have the same issue (rear end clunk over normal raod bumps) and have sway bar, links, etc with no problems obvious. ...
Question about Jeep Grand Cherokee
...sway bars, track/control arm, new tires,4x alignment, pwr steer pump Shaking so bad your fightn with steering wheel to drive and not go off road or hit anyone. When driving, going faster, slower or ...
...ball joints? It turns out to be the damn cheap swaybar bushing that jeep put on it. Look at the ends of the front and rear sway bars. There are links holding them on. Those stupid bushing are most ...
Question about Jeep Grand Cherokee
ball joint and sway bar link replacement. Procedures same for models from 1997 to 2004. Dodge Dakota Ball Joint Sway Bar Link Replacement The sway bar bushings are under the large clamps that hold the
Question about Jeep Grand Cherokee
...ball joint, or drive axle. You can test for bad ball joint by jacking car off the ground and grabbing the front wheel at 9 o'clock and 3 o'clock and moving back and forth or grabbing wheel at 12 ...
...they were good, was told it might be the ball joints but have to let it get worse, had the sway bar links replaced. can hear on both sides,does it on every bump may be boll joint or sway bar link
Question about Nissan Cars & Trucks
...Xterra very squeaky suspension. Front Struts? Lower Control Arms? Sway Bar links? Front Struts are original Sounds like ball joints/ control arms, could also be tie rods. Sway bar links not so
...problem. The ball joint went bad on the front left of the car. I had same problem and it was a broken spring 2000 S500 same sound, replaced bad ball joint but sound is still there, what could it
...ball joint. It fills with rust under boot due to non greasable style ball joint. Must use large bar to inspect these ball joints, to be able to lift through the rust. Good luck. Double check those ...
4,475 questions posted
Usually answered in minutes!
3,350 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions