2005 Dodge Stratus "crank sensor" Questions

...crank sensor I'm having excatly same problem, found this sequence to ge the car running again..turn off ign, unplug cam position sensor, crank for 2 seconds, connect cam shaft sensor, crank again ...

...it and the car has no spark. was the insulation on the wiring harness of your old crank sensor damaged in anyway. if it was damaged then it was also grounded which means you need to check your ...

crank sensor and is not that, we dont know what it could it be causing this problem, i am guessing it might be something electrical because it runs but then it turns off, like the power goes away, and

crank sensor. just because you have a code does not mean its a bad sensor. There are other reasons the code can set. The other half of the crank sensor is a magnet inside to cover. You need to inspect

...crank sensor. pull the codes from the vehicles computer. if there is a cam or crank sensor code, or if there is a code that says in some different wording "cam sensor signal does not match crank ...

crank position sensor and the other is the cam shaft position sensor. If either one cannot be "seen:" by the computer it will not start. what do you mean it won't crank no crank is no turning over the

...crank over. CRANKSHAFT POSITION SENSOR - 2.5L REMOVAL Remove speed control servo from driver's side strut tower. Remove crankshaft position sensor retaining bolt Crankshaft Position Sensor Pull ...

...crank sensor due to a problem with the sensor or the timing belt.Code 340 is for bank one sensor one.  You could have as many as 4 sensors depending on which engine you have.The mass airflow ...

crank shaft sensor and wire harness so I did. The car will not start. It will turn and sound like it wants to start but does not. What else could be wrong? Also after the sonsor was replaced the check

...sensor, crank sharf sensor and my car still won;t start it has fire like it want to crank should i check my fuel injector If you changed the camshaft and/or crankshaft sensor, it will need a CASE ...