2001 Ford Windstar "lift engine" Questions

how do I lift an engine to replace the motor mountss? you need a engine lift with three bar engine support and adapter.

...and disconnect heater water outlet tube from water pump. Remove A/C bracket brace. Attach engine lifting eye to left-hand (front) exhaust manifold (9430). Attach lifting equipment to engine

Remove water pump on 3.8 liter v-6; does this require removing engine mount and lifting engine? Yes.It has to come up about 5 inches.Remove the lower hose from the bottom.Hope this helps.Good luck.

...lift the van - pull the old engine off, install new one, lower van, reconnect everyting. Check first to see if the cross memeber is welded on one side. I had an 87 Buick Century that I had another ...

...can be hard to get to, and I have done some only after I have disconnected motor mounts and jacked up the engine to gain access-hard job to do on your back in some cases, so a lift is nice to

...line that goes to the back of the engine area, to take it to a garage because the vehicle must be lifted high enough to work on it safely and

...lift. WinStar van you have the two dog bones in the front all right and if you look at the dog bones one of them has a loop on it okay that Loop is set up to actually once you unbolt the dog bones ...

...back of the engine not much but when i look under i see about a quater of a cup on the ground. a lifted the van up but i cant see were the leak is coming from . i spoke to a mecanic and he told me ...

...engine and transmission meet.The vehicle needs to be lift on jackstand to get proper view and to easily remove the starter. --------- Thanks.Helpmech. On the front of the engine--you can see it from ...

...the water pump outlet tube bolt and position the tube assembly out of the way. 10. Install the lifting eye to the exhaust manifold. 11. Attach engine lifting equipment and raise the engine 127