2004 Ford Explorer "wires brake switch cruise control" Questions

Ad

...wires for corrosion and continuity I've seen this before and it's brake related but you must check all including the cruise control are you sure you weren't touching the set accelerator or resume ...

Ad

Question about Ford Explorer

1 Answer

...brake switch can make poor contact which reduces the current flow to the Cruise Control Servo. To test for this problem, find the brake switch with the Gray wire and Brown wire. Back probe and jumper ...

Ad

Question about Cars & Trucks

1 Answer

...brake switch B pin purple wire dead and 4 clock springs not bad after 19 years spinning the steering wheel like mad does the cruise lamp glow turned on???? no told. and is step #1 to actvate the ...

...stabilitrac, airbag light on, or good not fully closed I know u said u replaced the switch but most of the time your brake switch is the problem normally under 20 bucks and take 15 min to ...

Question about Ford Explorer

1 Answer

...wires) screwed into the brake cylinder (attached to the brake booster). This switch is a cruise system backup from the pedal switch and measures brake fluid pressure, to disengage the cruise control. ...

...Make sure the brake lights are not stuck on as the brake switch cancels cruise control when brakes are applied . Cruise control switch, fuse, connections and wiring can all cause non functioning

...if the brake lights work fine,the switch still could cause this problem,replace the brake light switch. check the wires going to the box under the hood and the wires to the switch on the steering ...

...brake system/traction control system is active for more than 2 seconds If the PCM determines that any of the cruise control inhibit conditions are present, the PCM will disengage the cruise control. ...

Question about Ford Explorer

1 Answer

...wires from the main brake switch on the pedel if you have a standard then it will run through the clutch switch as well .Fuse #12 also controls the muilty function switch but fuse #1 is the brake ...

...wires going to the module which is located at pins "G" and "J". There should be no voltage at pin "G" until the brake switch is applied. This switch is also used to ...

Not finding what you are looking for?
2004 Ford Explorer Logo

2,501 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

1999 Ford Explorer
1999 Ford Explorer

2,248 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2003 Ford Explorer
2003 Ford Explorer

1,369 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...