wire connector), you will also need a relay in the relay slot 15. If you did not use the factory connector for your trailer brake controller, check to make sure you have connected the controller to an
Question about Ford Explorer
...brake lights stayed on when no lights were on and the car was off. Check all fuses for the brakes this is a warning that something is wrong that's why your locked in park also check all contacts and ...
Question about Ford Explorer
...brake booster in the wire harness that runs along the frame to the rear. Im not exactly sure which cable that wire is in, but it will be the one that runs along the frame to the rear or the one that ...
a light came on that said ABS... what does that mean??? what does ABS mean when the light comes on my dash board on my truck??? It indicates that something is bad with your ABS subsystem. First, did ...
Brake lights keep fusing so car can not be put into gear no one can seem to find the problem does this use the little switch mounted on the master cylinder for the cruise control? if so, disconnect ...
...controls the brake lights. It should be a 20A fuse located in the fuse box in the vehicle. This fuse should always have power. This can be tested with a standard 12volt test light (available at any ...
...Brake lights working independent of the brakes. Contact a dealer about this SECOND service bulletin. The above problems are more likely if the 4x4 is showing a light and the vehicle is in 2 wheel ...
Question about Ford Explorer
2004 ford explorer ABS light on, cruise control quit working. Problem? THERE IS A BRAKE PRESSURE SWITCH MOUNTED ON THE MASTER CYLINDER. IF THE ABS LIGHT IS ON AND THE CRUISE CONTROL IS INOP. THE ...
...idle and slow speeds. Service engine light on. One code suggested misfire in cylinder 4? plugs and wires a good start Check the plug and the cable. Clean the rotor and the distributor cap contacts ...
2,501 questions posted
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,369 Questions